M U S T A N G Owner's Manual with Assembly Instructions Model: L6349 Product features may vary from the picture above. Please read this manual and save it with your original sales receipt. Tools needed for assembly: Phillips Screwdriver (not included); Assembly Tool (included). Use only with a Power Wheels® 12 Volt Rechargeable Battery and Power Wheels® 12 Volt Charger with Type 12V connector (both included). Requires three "AA" (LR6) alkaline batteries for simulated radio operation (not included).
TABLE OF CONTENTS A Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 B Warnings and Cautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 C Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
WARNINGS AND CAUTIONS B ELECTRICAL HAZARD WARNING • Battery can fall out and injure a child if vehicle tips over. Always use battery retainer. • PREVENT FIRE - Never modify the electrical system. Alterations could cause a fire resulting in serious injury and could also ruin the electrical system. - Use of the wrong type battery or charger could cause a fire or explosion resulting in serious injury.
PARTS C • If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than return this product to the store. • Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no parts are discarded. • Metal parts have been coated with a lubricant to protect them during shipment. Wipe all metal parts with a paper towel to remove any excess lubricant.
PARTS Steering Wheel C Steering Wheel Cap 12 Volt Battery 2 Bushings 4 Hubcaps 12 Volt Charger 2 Mirrors / " x 11/ 2" Pin - 1 5 32 / " -16 Lock Nut - 2 3 8 2 Mirror Covers #8 x 3/ 4" Screw - 27 Fastener Cap #8 x 3/ 4" Black Screw - 5 Assembly Tool / " x 11/ 4" Screw - 2 1 4 Steering Column / " Washer - 2 7 16 Long Seat Belt Part not shown: Label Sheet L6349pr-0920 2 Short Seat Belts For your convenience, we included extra fasteners! Note: Tighten and loosen all screws with a Phillip
PARTS DIAGRAM D 11 10 21 17 5 3 14 6 20 20 15 1 4 22 19 7 24 16 23 18 13 12 2 8 1 2 3 4 5 6 7 8 Vehicle Front Bumper Dash Assembly Hood Rear Deck Seat Bumper Support Front Wheels - 2 9 10 11 12 13 14 15 16 Wheel Covers - 2 Steering Wheel Steering Wheel Cap Hubcaps - 4 Bushings - 2 Mirrors - 2 Mirror Covers - 2 Fastener Cap 17 18 19 20 21 22 23 24 Steering Column 7/16" Washers - 2 Long Seat Belt Short Seat Belts - 2 5/32" x 11/ 2" Pin 12 Volt Battery 12 Volt Charger 3/8"-16 Lock Nu
BATTERY CHARGING ELECTRICAL HAZARD WARNING • Battery can fall out and injure a child if vehicle tips over. Always use battery retainer. • PREVENT FIRE - Never modify the electrical system. Alterations could cause a fire resulting in serious injury and could also ruin the electrical system. - Use of the wrong type battery or charger could cause a fire or explosion resulting in serious injury.
E BATTERY CHARGING B Power Indicator ASSEMBLY F WARNING Children can be harmed by small parts, sharp edges and sharp points in the vehicle's unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery, or help in assembly of the vehicle. A Charger Connector • Plug the charger connector into the battery A . • Plug the charger into a standard wall outlet. The power indicator lights B .
ASSEMBLY 2 F Front Bumper • Fit the front bumper to the vehicle. Bushing 4 Front Axle Washer • Slide a 7/16" washer onto a front axle. • Fit a bushing, flat side first, onto the front axle. 3 • Insert six #8 x 3/4" screws into the front bumper and tighten. 5 Front Wheel (Marked R) Wheel Cover Note: There is a right and left front wheel. They are marked with an R and L. • Locate the right front wheel marked with an R. Place the front wheel R, onto the front axle.
ASSEMBLY F Assembly Tool 6 Lock Nut • Fit a 3/8"-16 lock nut, rounded side out, onto the front axle. IMPORTANT! Tighten the lock nut firmly with the closed end of the assembly tool. • Test to be sure the front wheel moves freely on the front axle. Turn the front wheel. • If the front wheel does not move freely, loosen the lock nut ¼ turn and test again. Repeat this procedure as necessary.
ASSEMBLY F Dash Assembly Dash Connectors 12 • Insert four #8 x 3/4" screws into the dash assembly and tighten. 10 Motor Harness Connector • Position the motor harness connector toward the front of the vehicle. • Place the dash assembly upside down on top of the front end of the vehicle. • Plug the dash connector from the vehicle into the dash connector on the dash assembly. Hint: If the connectors do not fit together, do not force them. Simply turn one of them around and try again.
ASSEMBLY F 19 9 19 19 19 21 22 18 Battery Compartment Door 14 15 DASH VIEW • Before applying the labels, wipe the surface of the vehicle with a clean, dry cloth to remove any dust or oils. • Place the labels exactly as shown in the illustrations. For best results, avoid repositioning a label once it has been applied to the vehicle. 1.5V x 3 "AA" (LR6) Battery Safety Information In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product.
ASSEMBLY F Short Seat Belts Hood Seat Long Seat Belt 18 16 FRONT VIEW • Fit the long tabs on the hood into the slots in the front end of the vehicle. • Pull the hood forward and lower. Note: The hood is held down by magnets. Simply lift to open the hood. Do not use around items that are sensitive to or affected by magnetic fields. • Insert the fastener end of a short seat belt strap through the slot near the outer edge of the seat.
ASSEMBLY F Steering Column 20 BACK VIEW • Insert three black #8 x 3/4" screws into the back of the seat and tighten. Note: You will need to remove these three screws if you change the seat position later. 22 • Wipe the steering column with a paper towel to remove any excess lubricant. • Insert the straight end of the steering column down through the hole in the vehicle floor and out through the hole in the dash. Steering Linkage 21 BOTTOM VIEW • Turn the vehicle over.
ASSEMBLY F Fastener Cap Press Wheel 24 • Fit the fastener cap onto the end of the steering column. • Insert a #8 x 3/4" screw through the large opening in the fastener cap and into the hole in the steering column. Tighten the screw. • Turn the vehicle upright. 26 Lift Steering Column • While pressing down on the steering wheel, grasp the steering column under the dash and pull it up as far as it will go. • Insert the 5/32" x 11/2" pin through the hole in the steering column.
DECORATION G • Before applying the labels, wipe the surface of the vehicle with a clean, dry cloth to remove any dust or oils. • Place the labels exactly as shown in the illustrations. For best results, avoid repositioning a label once it has been applied to the vehicle. • After applying a label, rub the label firmly with a clean, dry cloth to make sure the label is adhered to your vehicle. Start at the center of a label, and smooth towards the outer edges to remove air bubbles.
DECORATION 10 1 1 1 G 3 2 Both sides 11 7 Label #6 on the opposite side 23 8 24 Both sides 20 24 Both sides 20 25 BACK VIEW L6349pr-0920 17
H BATTERY INSTALLATION IMPORTANT! Use only a Power Wheels® 12 volt lead-acid rechargeable battery. Use of any other battery will damage your vehicle. Make sure that you charge the battery for at least 18 hours using the enclosed Power Wheels® 12 volt charger before operating your vehicle for the first time. Charge the battery for at least 14 hours after each use of the vehicle. Never charge the battery longer than 30 hours.
BATTERY CARE AND DISPOSAL Care If a battery leak develops, avoid contact with the leaking acid and place the damaged battery in a plastic bag. See information below for proper disposal. If acid comes in contact with skin or eyes, flush with cool water for at least 15 minutes and call a physician. If acid is internally ingested, give water, milk of magnesia or egg whites immediately. Never give emetics or induce vomiting. Call a physician. • Charge a new battery for at least 18 hours before first use.
SAFE DRIVING RULES K RIDING HAZARD WARNING • Prevent Injuries and Deaths • Direct Adult Supervision Required • Never Ride at Night. • Keep Children Within Safe Riding Areas. These areas must be: - away from swimming pools and other bodies of water to prevent drownings - generally level to prevent tipovers - away from steps, steep inclines, cars, roads and alleys. • Riding Rules Make sure children know and follow these rules for safe driving and riding.
L VEHICLE OPERATION As assembled, your vehicle is ready to roll in low speed (21/2 mph, maximum). After your child has mastered the basic skills of driving and understands the rules for safe driving, it’s time to remove the high speed lock-out screw to allow the vehicle to operate in low or high speed. See the instructions on this page to remove the high speed lock-out screw. STOP IMPORTANT! Use this vehicle ONLY outdoors. Most interior flooring can be damaged by riding this vehicle indoors.
M VEHICLE OPERATION Press • Press the left button on the simulated radio for horn sounds and dashboard lights. • Press the right button on the simulated radio to hear cool tunes and see the "radio" light up. • Press the key for engine sounds and dashboard lights. 22 N VEHICLE CARE • Check all screws, cap nuts and their protective coverings regularly and tighten as required. Check plastic parts on a regular basis for cracks or broken pieces.
PROBLEMS AND SOLUTIONS GUIDE O IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you still experience a problem, please contact Power Wheels® Consumer Relations, toll-free at 1-800-348-0751 between 9 AM - 7 PM (EST) Monday through Friday or 11 AM - 5 PM (EST) Saturday. Or, contact your local Power Wheels® authorized service center. For the location nearest you, please visit us on-line at www.powerwheels.com, or call 1-800-348-0751.
O PROBLEMS AND SOLUTIONS GUIDE PROBLEM Short run time (Less than 1 - 3 hours per charge) POSSIBLE CAUSE Undercharged battery SOLUTION Charge the battery. A new battery should have been charged for at least 18 hours before using the vehicle for the first time. After firsttime use, recharge the battery for at least 14 hours after each use. Never charge the battery longer than 30 hours. Check all wires and connectors.
PROBLEMS AND SOLUTIONS GUIDE PROBLEM Vehicle runs in low speed, but does not run in high speed. POSSIBLE CAUSE SOLUTION High speed lock-out not disconnected. The vehicle was pre-set to run only in low speed. To allow the vehicle to run in low and high speed, you must disconnect the High Speed Lock-Out. Follow the instructions on page 20 to remove the High Speed Lock-Out screw.
P FCC STATEMENT United States Only This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
L6349pr-0920 27
Before first-time use, you must charge the battery 18 hours! Charge the battery immediately after each use. Charge the battery once a month, even if the vehicle is not used or stored. Do not return your vehicle to the store! We're a toll-free phone call away, and we can help. If you are missing parts or need assistance, please call: 1-800-348-0751 Or contact your local independently owned and operated Power Wheels® Authorized Service Center. For the location nearest you, visit us on-line at www.
