Model L5805 Super Sounds Soccer ™ www.fisher-price.com www.fisher-price.
PARTS Ball Pin Tube with Tapered End and Regular End (Upper) Target Net 2 Tubes with Tapered Ends (Upper and Lower) 2 Side Tubes Tube with Tapered End and Regular End (Lower) • Please keep this instruction sheet for future reference, as it contains important information. • Adult assembly is required. • Tool needed for assembly: Phillips Screwdriver (not included). • Hand pump (not included) and inflation pin (included) required to inflate the soccer ball.
ASSEMBLY CAUTION This product contains small parts in its unassembled state. Adult assembly is required. Rounded Side Long End Tapered End Side Tube Rounded Side Tube with Tapered Ends 2 • Fit the long end of a side tube onto either tapered end of the assembly. • Align the holes in the two tubes. Hint: If the holes in the tubes do not align, remove the side tube and place it on the other end of the assembly. • Fit a lock nut, rounded side out, into the hex hole in the inside of the side tube.
ASSEMBLY TOP OF NET Long Sleeve Side Sleeve Side Sleeve Short Sleeve 6 4 Binding Short Sleeve BOTTOM OF NET • Next, fit the long sleeve and other side sleeve on to the side tube. Note: The short sleeve should not be fitted onto the tube. • Lay the net on a flat surface. • Note the long sleeve, two side sleeves and two short sleeves on the net. - Long sleeve is the top of the net. - Binding is the bottom of the net.
ASSEMBLY Short Sleeve Short Sleeve Long End of Tube Long End of Tube 8 Short End of Tube 10 • Fit the long end of either remaining tube through the short sleeve. • Now, weave the tube through the openings on the edge of the net (about half way). Short End of Tube • Fit the long end of the remaining tube through the short sleeve and weave the tube through the openings on the edge of the net. Short End of Tube Short End of Tube 11 9 • Fit the short end of the tube into the frame assembly.
ASSEMBLY Rounded Side 14 • Insert the inflation pin into the ball. • Attach the pump (not included) to the pin. • Inflate the ball to a circumference of 15 1/2" (39 cm), until firm. Do not over-inflate. • After inflating the ball, remove the pin. Store the pin out of the reach of children for future use. 12 • Fit the ends of the tubes together. • Fit a lock nut, rounded side out, into the hex hole on the inside of the tube assembly. • Insert a screw through the hole in the outside of the tube assembly.
BATTERY INSTALLATION BEGINNER Beginner’s score fun sounds when the ball hits the net! Power/Mode Switch Tab Net Battery Compartment Door Target Top Edge of the Frame 1.5V x 3 "AAA" (LR03) • Locate the power/mode switch on the back of the target. Slide the switch to 1 for beginners. • Fit the target onto the top edge of the frame. • Fit the tab on the back of the target onto a net loop. SHOWN ACTUAL SIZE • Loosen the screws in the battery compartment door and remove the battery compartment door.
PRO CONSUMER INFORMATION Hit the target like a pro for fun sounds! CARE • The frame and net may be wiped clean using a mild cleaning solution and a damp cloth. Do not use bleach. Do not use harsh or abrasive cleaners. Rinse clean with water to remove residue. Do not immerse this toy. • To prolong the life of the net, store this toy indoors. • Periodically check all fasteners regularly to be sure they are tight. If the fasteners are not tight, tighten them as necessary.