Action Sounds B A S K E T B A L L Model K9125 1 www.fisher-price.
Consumer Information CARE CAUTION • The frame and net may be wiped clean using a mild cleaning solution and a damp cloth. Do not use bleach. Do not use harsh or abrasive cleaners. Rinse clean with water to remove residue. Do not immerse this toy. • To prolong the life of the net, store this toy indoors. • Do not leave this toy outside in freezing weather. Water left inside the base will freeze and possibly damage the base.
Parts Hint: Some parts were placed inside the lower post for shipping. Upper Post Backboard 4 Rim 5 Collar Sound Box 6 Paddle Lower Post Ball Plug Base #6 x 3/4" (1.9 cm) Screw - 4 #8 x 2 1/4" (5.7 cm) Screw - 1 BOTH SHOWN ACTUAL SIZE Note: Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten.
Assembly 7 Curved End 4 Upper Post 2 1 5 Side Edge 5 6 6 Large Square Opening 4 3 Base 3 1 • Position the base as shown. • Position the upper post so that the straight end is down and the curved end is up and facing away from the base. Hint: For easier assembly, apply liquid soap or rub a candle or bar soap around the bottom of the upper post (especially on the corners) and the inside of the large square opening. If assembling inside, place a tarp under the base to protect the floor surface.
Assembly Wall Backboard Rim Labels Soundbox 4 Groove 5 Upper Post Peg 6 5 Paddle 7 • Lean the rim against a wall for support. • Locate the pegs on each side of the rim and the grooves on the backboard. • Position the backboard with the label side facing up. • Place your foot on the base to hold it steady and slide the backboard onto the upper post at an angle, as far as it will go. Note: There should be no gap between the upper post and the backboard. • Move the assembly away from the wall.
Assembly Peg Peg Lower Post 4 Holes Rib 5 11 Groove Base 6 • If the lever comes off, simply re-attach it. • Insert the peg on one side of the lever into the hole in the collar. • Snap the other peg in the lever into the other hole in the collar. Assembly is now complete. Please refer to assembly step 2 to fill the base with water or approximately 50 lbs. (22.7 kg) of sand (water and sand not included) to keep this product stationary.
Adjusting The Rim Height Backboard 4 4 5 Slots 5 Upper Post 6 Lever 6 Lower Post Upper Post Base 1 3 • As assembled, the rim height is 3' (1 m). • To raise the rim height to 4', 5', or 6' (1.2 m, 1.5 m or 1.8 m), place your foot on the base and pull up on the backboard with both hands to remove the upper post from the base. You may need to rock the upper post to loosen it from the base. • To lower the rim height: while holding the upper post, push the lever on the lower post down.
Maintenance Battery Replacement Tip: We recommend the use of alkaline batteries for longer battery life! 1.5V x 3 "AAA" (LR03) Shown Actual Size • This toy includes an inflatable ball. If the ball becomes soft, inflate it with a standard, manual air pump with a standard air needle. • The ball will contain the correct amount of air when its circumference measures about 19-20 inches (48-51 cm).