J6998 WARNING PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. www.fisher-price.
Important! • For proper setup and use, please read these instructions. • Transmitter operates on AC current. • Receiver operates on AC current (use enclosed AC adaptor) or three “AAA” (LR03) alkaline batteries (batteries not included). • Adult assembly is required to install batteries (if used). • Tool needed for battery installation: Phillips screwdriver (not included). • This product is not intended to be used as a medical monitor and its use should not replace adult supervision.
Features Flexible Antenna Night Light - press to turn on a soft glow Power Indicator Microphone Channel Switch Power Button TRANSMITTER 3
Features Flexible Flexible Antenna Antenna Clip (backside of receiver) – Fasten to your clothes to stay in touch with baby around the house or yard. Sound Lights - let you see baby’s sounds. Power Indicator On/Off/Volume Dial - turns power on. Set volume to a comfortable level.
Receiver Battery Installation (Optional) Battery Safety Information In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Insert batteries as indicated inside the battery compartment. • Remove batteries during long periods of non-use. Always remove exhausted batteries from the product.
Testing Sound Reception Test transmitter transmission and receiver reception each time you change location of use. Adjust Channel Static Buzzzz Power Button • Place transmitter in room in which you intend to use it. • Press transmitter power button to turn power on. Power indicator lights. • Set transmitter channel switch to same channel as receiver. Turn on a radio. Low Battery Indicator • Sound lights turn on when sound is received by the receiver. - One or two lights for shallow sounds.
Setup & Use IMPORTANT! Test sound reception of this monitor before first time use and whenever you change location of transmitter (see page 6). Adjust Channel • Place receiver where you will see or hear it. • Unwrap and fully extend AC adaptor cord for best reception. Insert AC adaptor jack into receiver socket and plug into wall outlet. Use the AC adaptor only in a wall outlet. Do not plug the AC adaptor into a celing outlet. Note: To use batteries as a power source, refer to instructions on page 5.
Problems & Solutions Problem You hear static or buzzing Solution Receiver is out of range of transmitter. Move receiver closer to transmitter. Note: Range varies depending on surrounding conditions such as noise levels, physical obstructions and signal interference. Transmitter power is off. Turn transmitter power on. Channel switches are on different channels. Make sure channel switches on both transmitter and receiver are set to same channel. Loose power cord connection and transmitter power is off.