User Manual

1100317554-DOM
CJG60-0970-G2
©2015 Mattel. All Rights Reserved. Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A. Consumer Relations
1-800-524-8697. Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline 01628 500303. Mattel Australia Pty.,
Ltd., Richmond, Victoria. 3121.Consumer Advisory Service - 1300 135 312. Mattel East Asia Ltd., Room 503-09, North Tower, World
Finance Centre, Harbour City, Tsimshatsui, HK, China. Tel.: [phone]. Diimport & Diedarkan Oleh: Mattel SEA Ptd
Ltd.(993532-P) Lot 13.5, 13th Floor, Menara Lien Hoe, Persiaran Tropicana Golf Country Resort, 47410 PJ. Malaysia.
Tel:[phone], Fax:[phone].
CONTENTS
1
4
REMOVING DARTS
6
CLEANING DARTS
7
Dust, dirt, and other debris can cause
darts to lose their adhesiveness.
Keep one hand pressed on target, hold
dart by the tip and gently peel dart off.
To clean darts, rinse darts’ tips with
tap water or use tape to remove
excess debris.
DATE: 02.12.15
2
BATTERY INSTALLATION
1
™
™
Please keep these instructions for future reference as they contain important information.
GAUNTLET
INSTRUCTIONS
SPINSANITY 3X™
WARNING: Do not aim at eyes or face. Only use projectiles supplied with
this toy. Do not fire at point blank range.
TO AVOID INJURY: Do not modify rounds, darts, or dart blaster.
Always wear appropriate eye-wear, sold separately.
REMOVE DARTS
TECHNOLOGY!
IMMEDIATELY
TO MAINTAIN SMART STICK™
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
• Requires 6 AA (LR6) alkaline batteries (not included).
• Unscrew the battery cover with a Phillips head screwdriver (not included).
• Install 6 new AA (LR6) alkaline batteries in the orientation (+/-) shown.
• Replace battery cover and tighten screw.
• Replace batteries if motor slows down.
• For best performance, use alkaline batteries.
Protect the environment by not disposing of this product with household waste
(2002/96/EC). Check your local authority for recycling advice and facilities.
NOTE: Dry darts before using again.
x6
AA (LR6)
ALKALINE BATTERIES
REQUIRED
NOT INCLUDED
8
A. Fully load the two bottom chambers with darts.
C. Hold button to rev motor. Pull trigger and release quickly for single fire!
D. Rev motor. Fully press and fully release trigger repeatedly for rapid fire!
B.
E. Hold button and pump the grip to advance to the next chamber.
Blaster may be jammed if it is loaded but will not fire:
3
TO PLAY
4
PERFORMANCE TIPS
5
ATTACHING TARGETS
1
4
3
2
✖
Do not stick target to walls
or furniture as it may cause
damage to the surface.
To clear a jam, hold button and pump the grip to eject the jammed dart.
a
a
BACK VIEW
a
BACK VIEW
BACK VIEW
a
b
b
b
INSTRUCTION SHEET
SPECIFICATIONS
Toy:
Toy No.:
Part No.:
Trim Size:
Folded Size:
Type of Fold:
# colors:
Colors:
Paper Stock:
Paper Weight:
EDM No.:
CJG60
G2
SPINSANITY 3X
A4
70 gsm
One
black
FSC recycled paper
NOTE: Darts should be pushed all the way
back and locked under the tabs when loaded.
Peel backing off target before sticking it to surface.
IMPORTANT: Chambers must be properly aligned to blaster when revving motor.
a
a
b
c
Hold button and pump to access top
chamber. Continue Loading.
a
BACK VIEW
b
x
30
x
3
Attach chambers to blaster before play.
b
c
Click!
Click!
a
a
1
BACK VIEW
2
BACK VIEW
X2