User Manual

2. PLAY MODES
REVVIT, WHERE
ARE YOU?
FOLLOW ME MODEFIND ME MODE
DANCE / WRECK MODE
To enter PLAY MODES: Press the FUNCTION BUTTON on Ty’s back.
(Press the FUNCTION BUTTON to toggle between PLAY MODES
and REMOTE CONTROL MODE.)
Point the remote control at the front of Ty.
Press and release the UP BUTTON on the
remote control once to enter FIND ME MODE.
Before Ty counts to five, put the remote
control on the floor and see if Ty can find it.
Point the remote control at Ty.
Press and hold the DOWN BUTTON.
Now Ty will follow wherever you go.
Point the remote control at Ty. Press the
WRECK/DANCE BUTTON to wreck or dance with Ty.
P
P
r
e
B
P
W
HELPFUL
HINT
REMOTE CONTROL
Works best within a
4 FT to 8 FT range.
HELPFUL
HINT
For proper function, put the remote
control on the same flat surface as Ty.
Make sure the remote control is
pointing at the infrared LEDs above
his treads, and there are no
obstacles blocking the
line of sight.
supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside
may explode or leak.
Protect the environment by not disposing
of this product with household waste
(2012/19/EU). Check your local authority
for recycling advice and facilities.
QUICK TIPS
(1) When your vehicle starts to lose power, it may lose
functionality or performance. It’s time for fresh batteries.
Your vehicle’s running time may change depending on your
driving style and driving environment.
(2) Interference can affect your vehicle's performance.
Interference can be caused by other I/R devices like a TV
remote control or other remotes in the house. Try to stay
away from these!
(3) Point the transmitter toward the vehicle. If your vehicle
gets too far away, it won’t work properly.
(4) Don't drive your vehicle in sand or through water or snow.
If your vehicle does get wet, wipe it with a towel and allow
to dry completely overnight.
(5) Don’t store your vehicle near heat or in direct sunlight.
Always turn switches OFF and remove all batteries for
storage.
(6) Do not obstruct the line of sight.
(7) Do not exceed the specified range.
(8) To conserve battery life, Ty Rux goes to sleep when left
idle for 5 minutes. To wake him up, press the FUNCTION
BUTTON on his back.
CONSUMER INFORMATION
Note to Adults: To ensure that the child’s play is both safe
and fun, please review all operating instructions and safety
rules with your child.
• NEVER drive your vehicle on streets! Streets are for real cars!
• DO NOT pick up the vehicle while it is in motion.
• Keep fingers, hair and loose clothing away from the wheels
while the vehicle is switched ON.
• Adult supervision is recommended while this toy is being
operated.
• When not in use, turn off the vehicle. To avoid accidental
operation, remove all batteries.
• This product is not recommended for use on loose dirt or wet
surfaces
DKD34-0970
1100979218_DOM
BATTERY INSTALLATION
Ty Rux requires 4 AA (LR06) alkaline batteries, not included. Remote
control requires 3 AAA (LR03) alkaline batteries, not included. For
longer life, use alkaline batteries. Dispose of batteries safely.
TY RUX
1. Unscrew the battery cover
with a Phillips head
screwdriver (not included).
2. Install 4 AA (LR06) alkaline
batteries with polarity (+/-)
as shown inside the battery
compartment.
3. Replace battery cover and
tighten screws.
NOTE: When exposed to an electrostatic source, the toy may
malfunction. To resume normal operation, turn the power OFF and
ON again. This should reset the toy and let you resume normal
operation.
REMOTE CONTROL
1. Unscrew the battery cover
with a Phillips head
screwdriver (not included).
2. Install 3 AAA (LR03)
Alkaline batteries with
polarity (+/-) as shown
insidethe battery
compartment.
3. Replace battery cover and tighten screw.
NOTE: Once batteries are installed, the remote control will always
be “ON”and will work the moment you use it. When exposed to an
electrostatic source, the remote control may malfunction. To
resume normal operation, remove and re-install the batteries.
This should reset the remote control and let you resume normal
operation.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid
battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product
before being charged.
• Rechargeable batteries are only to be charged under adult
FOR PRODUCT SOLD IN USA
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
• This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications not expressly approved by the manufacturer responsible
for compliance could void the user’s authority to operate the equipment.
FOR PRODUCT SOLD IN CANADA • POUR
LES PRODUITS VENDUS AU CANADA CAN
ICES-3 (B)/NMB-3(B)
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes :
(1) il ne doit pas produire de brouillage et (2) il doit pouvoir tolérer tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de compromettre son fonctionnement.
©2016 Mattel. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, except as
noted. Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A. Consumer Services
1-800-524-8697. Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline
01628 500303. Mattel Australia Pty., Ltd., Richmond, Victoria. 3121. Consumer Advisory
Service - 1300 135 312. Mattel East Asia Ltd., Room 503-09, North Tower, World Finance
Centre, Harbour City, Tsimshatsui, HK, China. Tel.: [phone]. Diimport & Diedarkan
Oleh: Mattel Southeast Asia Pte. Ltd. , No 19-1, Tower 3 Avenue 7, Bangsar South City, No 8,
Jalan Kerinchi, 59200 Kuala Lumpur, Malaysia.Tel: [phone], Fax: [phone].
Dinotrux © 2016 DreamWorks Animation LLC.
All Rights Reserved.
CAUTION: To prevent entanglement, keep all hair
away from the wheels.
REMOTE
REVVIT
TY
*REMOTE CONTROL MUST ALWAYS BE IN FRONT
OF TY AND POINTED AT TY IN ORDER TO PLAY.
I’LL FOLLOW
YOU BUDDY!
+
+
CONTENTS
Please keep these instructions for future
reference as they contain important information.
IMPORTANT: Please read all instructions before
operating your toy.
HELPFUL
HINT
VOLUME CONTROL
Ty has 2 volume settings
(High/Low).
Press and hold the FUNCTION
BUTTON for 2 seconds to
change between
the settings.
RIGHTWRONG
1 Switch Ty ON.
2 Stand directly in front of Ty with the
remote control pointed at Ty.
3 When prompted, press the UP BUTTON.
4 Ty will enter REMOTE CONTROL MODE
when you hear him say, "I can see you,
buddy. That’s the perfect spot!”
IMPORTANT: For proper function, keep the remote
control pointing at the infrared LEDs above Ty’s treads.
Do not cover up the infrared LEDs with your fingers.
BACKWARDFORWARD
1. REMOTE CONTROL MODE
SPIN
Press & Release
to Turn
Press & Hold
to Spin
TURN
UP BUTTON
RED LED
WRECK/DANCE BUTTON
DOWN BUTTON
INFRARED LED
BATTERY COVER
WRECKING BALL
POWER SWITCH
FUNCTION BUTTON / VOLUME CONTROL
INFRARED LED
INSTRUCTION SHEET
SPECIFICATIONS
Toy:
Toy No.:
Part No.:
Trim Size:
Folded Size:
Type of Fold:
# colors:
Colors:
Paper Stock:
Paper Weight:
EDM No.:
DINOTRUX HERO REVVIT
DKD34
0970
A2
A5
4C
CMYK
Art paper