DFP73 Some features of this product only work with the Fisher-Price® Smart Connect™ app. Download the Fisher-Price® Smart Connect™ app to control this product from your smart device (not included). This app is available from the App StoreSM or Google Play™. Please keep this instruction sheet for future reference, as it contains important information. Requires four D (LR20) alkaline batteries (not included) for operation. Adult assembly is required. Tool required: Phillips screwdriver (not included).
Consumer Information WARNING Prevent Entanglement Injury • Keep mobile out of baby’s reach. • Remove mobile portion of product from crib or playpen when baby begins to push up on hands and knees. • This product may not attach to all crib designs. Do not add additional strings or straps to attach to a crib or playpen. • Use ONLY attached to a crib. • Use as a mobile from birth to 5 months. • The soother can be used from birth until 36 months.
Consumer Information Care Wipe this toy with a clean, damp cloth. Do not immerse. Industry Canada (IC) Statement This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Consumer Information FCC STATEMENT (UNITED STATES ONLY) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Battery Installation 1,5V x 4 D (LR20) For longer life, use alkaline batteries. • Loosen the screws in the battery compartment door and remove the door. • Insert four D (LR20) alkaline batteries. • Replace the battery compartment door and tighten the screws. • If this toy begins to operate erratically, you may need to reset the electronics. Slide the power switch off and back on. • When sounds/lights/projection become faint or stop, it’s time for an adult to change the batteries.
Assembled Parts Canopy Arm Crib Adaptor Soother Mobile Adaptor Note: All of the screws used to assemble this toy are attached to the product. Follow these instructions carefully to fully secure the screws. Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten the screws.
Assembly Canopy Arm 1 • Fit the canopy onto the peg on the end of the arm. Push to “snap” in place. 2 Mobile Adaptor • Fit the arm into the socket in the mobile adaptor. Push to “snap” in place.
Assembly Soother 3 • Fit the mobile assembly onto the back of the soother. Tighten all four screws. Crib Adaptor 4 • Fit the crib adaptor onto the mobile adaptor. Tighten the two screws.
Crib Attachment IMPORTANT! Always attach all provided fasteners (strings, straps, clamps, etc.) tightly to a crib or playpen according to the instructions. Check frequently. 2 Crib Rail 1 4 1 3 Attachment Strap Peg • Position the toy inside the crib. Make sure the attachment strap is on the outside of the crib 1 . • Slide the end of the attachment strap down through the slot on the back of the toy 2 . • Pull the end of the attachment strap up and fasten to the peg on the back of the toy 3 .
Crib Attachment 2 • Tie the toy’s strings to a crib spindle. Note: It is better to tie the strings in a knot than a bow, since a bow may be easily untied. 7" 7" (18 cm) 3 • If the distance between the base and the mattress is less than 7 inches (18 cm), lower the crib mattress.
Use Light Button Press to turn the check light ON or OFF. Hint: The check light times out after approximately one minute. Volume Buttons Press to adjust the volume level. Mobile/Projector Button Press to turn on the mobile and projector. Press the button again to turn on the mobile only. Press the button again to turn off the mobile. Music/Sound Selection Buttons Press to turn on white noise. Press again to turn off white noise. Press to turn on sound effects. Press again to turn off sound effects.
Convert to Soother 1 3 2 • Remove the mobile from the crib. • Loosen the screws in the crib adaptor and remove it 1 . • Loosen the screws in the mobile assembly and remove it 2 . Store the mobile in a safe place for future use. • Fit the crib adaptor onto the back of the soother and tighten the screws 3 . • Attach the soother to the crib. Please refer to the Crib Attachment section for instructions.
Pairing Your Device Before using the Smart Connect™ app for the first time, you will need to pair your device with the mobile. Pairing Button • Open the Smart Connect™ app on your device. Be sure your device is within approximately 6 feet (1,8 meters) of the mobile to pair. • Next, slide the mobile power switch ON. • Then, press the pairing button on the back of the mobile. The mobile will stay in the pairing mode for approximately 30 seconds.
Smart Connect™ App App features and decorations shown in photographs and illustrations may vary. Press the switch icon to turn the Smart Messages ON or OFF. When Smart Messages are enabled you will receive pop-up notifications on your device to tell you the status of your mobile. Press the mobile icon to open the mobile controls. Press the Music On the Go icon to play songs from your device. Press the back icon to return to the home screen. Press the play/pause icon to start or stop music.
Smart Connect™ App Press to connect or disconnect your device from the mobile. View your device status here: You’re Connecting, You’re Connected, You’re Not Connected or Your mobile is out of range, turned off or asleep. Press to choose how long the mobile will stay on. Press to turn the check light ON. Press the icon again to turn the check light OFF. Press to turn the mobile ON. Press the icon again to turn the mobile OFF. Press to turn the mobile and projector ON.
Smart Connect ™ App Compatibility The Fisher-Price® Smart Connect™ app is compatible with the devices listed in the table.