User Manual

BATTERY INSTALLATION
• Unscrew and lift away cover from side of product.
• Replace batteries as indicated inside the battery compartment.
• Batteries included are for demonstration purposes only.
• For longer life use only alkaline batteries.
• If the product begins to malfunction, check the battery
installation. You may need to reset the electronics by removing
the batteries and reinstalling them. If the product continues to
malfunction or no longer operates, remove the batteries from
the toy and replace them with fresh batteries.
• Requires 3 “AG13” (LR44) batteries.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak  uids that can
cause a chemical burn injury or ruin your product. To avoid
battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product
before being charged.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a  re. The batteries inside may
explode or leak.
Keep these instructions for future reference
as they contain important information.
WHAT’S INCLUDED
WHAT’S INCLUDED
WHAT’S INCLUDED
WHAT’S INCLUDED
BATTERY INFORMATION
BATTERY INFORMATION
BATTERY INFORMATION
BATTERY INFORMATION
TM
TM
X1
X1X1
X1
DFM70
DFM70-0970
1100861987-DOM
HELPFUL HINTS
HELPFUL HINTS
HELPFUL HINTS
HELPFUL HINTS
Item No : DFM70-0970 / 1100861987-DOM
Blank Size : A3
Paper : Recycle Paper, 70 gsm
Color : Black
Date : Dec, 31, 2015 (Lily Liang)
X1
X1
X1
Folding method:
Cover
Cover
DFM70
DFM70-0970
xxxxxxxxxx-DOM
DFM70
DFM70-0970
xxxxxxxxxx
-DOM
STEAMWORKS REPAIR STATION
STEAMWORKS REPAIR STATION
STEAMWORKS REPAIR STATIONSTEAMWORKS REPAIR STATION
STEAMWORKS REPAIR STATION
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired
operation of the device.
L’utilisation de ce dispositif est autorisée seulement aux conditions
suivantes : (1) il ne doit pas produire de brouillage et (2) il doit
pouvoir tolérer tout brouillage radioélectrique reçu, même si ce
brouillage est susceptible de compromettre son fonctionnement.
Note: May not work with all engines.
ADULT ASSEMBLY
REQUIRED.
No tools needed.
ONE-TIME SNAPS: Assembly step
that is marked with a star is
“one-time snap”. Once this part
is put together, it cannot be
taken apart.
WARNING:
CHOKING HAZARD – Small parts.
Not for children under 3 years.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modi cations not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment. This device complies with
Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
1,5V x 3
“AG13” (LR44)
REQUIRED TOOL:
PHILLIPS SCREWDRIVER
(NOT INCLUDED).
©2016 Mattel. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel,
except as noted. PRINTED IN CHINA.
Mattel East Asia Ltd., Room 503-09, North Tower, World Finance Centre, Harbour City,
Tsimshatsui, HK, China. Tel.: [phone].
CO
N
SU
MER
ASS
I
S
T
A
N
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
Based on the Railway Series by The Reverend W Awdry.
©2016 Gullane (Thomas) Limited. Thomas the Tank Engine & Friends and
Thomas & Friends are trademarks of Gullane (Thomas) Limited.
©2016 HIT Entertainment Limited. HIT and the HIT logo are trademarks of
HIT Entertainment Limited.
Protect the environment by not disposing of this product
with household waste (2012/19/EU). Check your local
authority for recycling advice and facilities.
LABEL PLACEMENT
LABEL PLACEMENT
LABEL PLACEMENT
LABEL PLACEMENT
X1