User Manual

ManualsBrandsFisher-Price ManualsBaby Bouncers & RockersBaby's Bouncer

fisher-price.com

CMR11

IMPORTANT! Keep this instruction sheet

for future reference, as it contains

important information.

• Please read these instructions before

assembly and use of this product.

• Adult assembly is required. Tool needed for

assembly: Phillips Screwdriver (not included).

• Assembly instructions on back side of

this sheet.

• Requires one D (LR20) alkaline battery

(not included) for soothing unit operation.

• Use from birth until child is able to sit

up unassisted.

• Please remove all parts from the package and

identify them before assembly. Some parts

may be packed in the pad.

• Product features and decorations may vary

from photographs.

¡IMPORTANTE! Guardar estas instrucciones para

futura referencia, ya que contienen información

de importancia acerca de este producto.

• Leer estas instrucciones antes de ensamblar

y usar este producto.

• Requiere montaje por un adulto. Herramienta

necesaria para el montaje: desatornillador de

cruz (no incluido).

• Ver el dorso de esta hoja para las

instrucciones de montaje.

• La unidad relajante funciona con 1 pila

alcalina D (LR20) x 1,5V (no incluida).

• Usar a partir del nacimiento y hasta que el

bebé pueda incorporarse por sí solo.

• Sacar todas las piezas del empaque

e identificarlas previo al montaje. Algunas

piezas pueden venir embaladas en el colchón.

• Las características y decoración del producto

pueden variar de las mostradas.

MR11

K thi i t ti h t

Summary of content (10 pages)

PAGE 1
CMR11 IMPORTANT! RTANT! K Keep thi this iinstruction t ti sheet h t for future reference, as it contains important information. • Please read these instructions before assembly and use of this product. • Adult assembly is required. Tool needed for assembly: Phillips Screwdriver (not included). • Assembly instructions on back side of this sheet. • Requires one D (LR20) alkaline battery (not included) for soothing unit operation. • Use from birth until child is able to sit up unassisted.
PAGE 2
Consumer Information Información al consumidor WARNING Fall Hazard: Babies have suffered skull fractures falling while in and from bouncers. • Use bouncer ONLY on floor. • ALWAYS use restraints. Adjust to fit snugly. • NEVER lift or carry baby in bouncer. • NEVER use toy bar as a handle. Suffocation Hazard: Babies have suffocated when bouncers tipped over on soft surfaces. • NEVER use on a bed, sofa, cushion, or other soft surface. • NEVER leave baby unattended.
PAGE 3
Securing Your Infant Sistema de sujeción ón Restraint Pad Almohadilla de sujeción 2 1 TIGHTEN APRETAR LOOSEN OOSEN AFLOJAR FLOJAR To tighten the restraint belts: • Feed the anchored end of the restraint traint belt up through the buckle to form a loop A . Pull the free end of the restraint belt B . To loosen the restraint belts: • Feed the free end of the restraint belt up through the buckle to form a loop p A. Enlarge the loop by pulling on the end d off th the loop toward the buckle.
PAGE 4
Care Mantenimiento Soothing Unit Unidad relajante • The pad is machine washable. Wash it separately in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly. • To remove the pad: Pull to remove the pad from around the retainers and the soothing unit. Remove the bottom pocket of the pad from the footrest. Lift to remove the pad. • To replace the pad, refer to Assembly steps 6 - 7.
PAGE 5
Parts Piezas Pad Almohadilla Toy Bar Barra de juguetes Seat Back Tube Tubo del respaldo Footrest Reposapiés Left Base Wire Tubo de base izquierdo 2 Feet 2 patas Base Tube Tubo de la base Right Base Wire Tubo de base derecho M5 x 20 mm Screw – 4 Tornillo M5 x 20 mm – 4 Note: Screw shown actual size. Tighten or loosen all screws with a Phillips screwdriver. Do not over-tighten the screws. Atención: el tornillo se muestra a tamaño real.
PAGE 6
Assembly Montaje IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. Do not use the product if any parts are missing, damaged or broken. Do not use accessories or replacement parts other than those approved by the manufacturer. Never substitute parts. ¡IMPORTANTE! Antes del montaje y de cada uso, revisar que el producto no tenga piezas dañadas, conexiones sueltas, piezas faltantes o bordes filosos.
PAGE 7
Assembly Montaje Footrest Reposapiés Seat Back Tube Tubo del respaldo Retainer Socket Up Conexión de retenedor hacia arriba Base Wires Tubos de base 4 • Position the footrest so that the soothing unit is upright. • Fit the footrest onto the ends of the base wires. 5 • Colocar el reposapiés de modo que la unidad relajante esté en posición vertical. • Ajustar el reposapiés en los extremos de los tubos de la base. • Make sure the socket in each retainer is upright.
PAGE 8
Assembly Montaje • Introducir los retenedores en los orificios laterales de la almohadilla. • Ajustar los bordes de la unidad relajante en el orificio grande del frente de la almohadilla. Toy Bar Plugs Enchufes de la barra de juguetes 6 • Position the pad above the frame. • Fit the upper pocket on the back of the pad onto the seat back tube. • Fit the lower pocket on the back of the pad onto the footrest. • Colocar la almohadilla sobre el armazón.
PAGE 9
Battery Installation Colocación de la pila Hint: We recommend using an alkaline battery for longer battery life. • Replace the battery compartment door and tighten the screw. • Pull and fit the pad seat bottom pocket around the soothing unit and footrest. • If this product begins to operate erratically, you may need to reset the electronics. Slide the power switch off and then back on. Atención: se recomienda usar una pila alcalina para una mayor duración.
PAGE 10
Battery Safety Information In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Insert batteries as indicated inside the battery compartment. • Remove batteries during long periods of non-use. Always remove exhausted batteries from the product. Dispose of batteries safely.