Product features and decorations may vary from picture above. Instructions Model Number: H4788 WARNING IMPORTANT! KEEP FOR FUTURE REFERENCE. Please read these instructions before assembly and use of this product. Adult assembly is required. Tool needed for assembly: Phillips Screwdriver (not included). Requires four “D” (LR20) alkaline batteries (not included) for operation. www.fisher-price.
Parts WARNING To prevent serious injury or death: • It is dangerous to use this reclined cradle on an elevated surface, since child's movement may cause infant seat to slide or tip over. • Never use on a soft surface (bed, sofa, cushion), since seat can tip over and cause suffocation in soft surfaces. • Always use the restraint system. • Never leave the child unattended. • Never use as a car seat. • Not recommended for children who can sit up by themselves (6 months approximately, until 9 kg (20 lbs).
Assembly IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Mattel for replacement parts and instructions if needed. Never substitute parts. M5 x 20 mm Screw - 2 Base Tube Holes Left Base Wire 1 3 Right Base Wire • Insert an M5 x 20 mm screw through each foot and tighten. • Place the base tube on a flat surface, with the holes facing you.
Assembly Groove Retainers Footrest Wire/ Seat Back Tube 7 5 •Fit the footrest wire/seat back tube into the groove in the retainer. Base Wires • Fit the base wires into the slots in the retainers on the liner. Push the retainers down. #6 x 2.86 cm Red Shoulder Screw – 2 #8 x 2.22 cm Screw – 2 Footrest Wire/ Seat Back Tube Retainer Lower Hole 8 • Insert a #6 x 2.86 cm red shoulder screw through the seatback tube, footrest wire and into the retainer. Tighten the screw.
Assembly Pad Liner 9 11 • Attach the fasteners at the top and sides of the pad. • Fit the pad into the liner. Pad Bottom Pocket Toys 10 • Pull and fit the pad seat bottom pocket around the soothing unit and footrest. • Fit the restraint straps through the slots in the pad. 12 • Fit any of the toy straps through a toy ring. Now, fasten the toy strap. Assembly is now complete.
Battery Installation Hint: We recommend using alkaline batteries for longer battery life. _ 1,5V x 4 LR20 (“D”) Soother Battery Compartment Massager Battery Compartment + 2 Shown Actual Size • Locate the electronic unit on the footrest wire. You will see that there are two battery compartments. The smaller compartment powers the soother; the larger battery compartment powers the massager. • First, loosen the screw in the soother battery compartment door and remove the battery compartment door.
Setup and Use WARNING Restraint Pad To prevent serious injury or death: • It is dangerous to use this reclined cradle on an elevated surface, since child's movement may cause infant seat to slide or tip over. • Never use on a soft surface (bed, sofa, cushion), since seat can tip over and cause suffocation in soft surfaces. • Always use the restraint system. • Never leave the child unattended. • Never use as a car seat.
Soother and Massage • Make sure your child is properly secured in the seat. Slide the vibrations switch: Vibrations On Off Note: If vibrations become faint or if there are no vibrations, remove the battery from the small battery compartment and throw it away. Replace the battery with a new, “D” (LR20) alkaline battery. Slide the sound switch to choose: Lullabies Music New Age Music Nature Sounds Off Note: Music/Sounds turn off after approximately 8 minutes.