Instruction Sheet

ManualsBrandsFisher-Price ManualsBicycleB8776

Product features and decoration may vary from the photograph above.

www.ﬁ sher-price.com

B8776

Please keep this instruction sheet for future reference,

as it contains important information.

Adult assembly is required.

Tools required for assembly: Phillips Screwdriver,

Hammer and Scrap Block of Wood (not included).

Age: 2-5 years

Weight limit: 55 lbs (25 kg).

Summary of content (6 pages)

PAGE 1
B8776 Product features and decoration may vary from the photograph above. Please keep this instruction sheet for future reference, as it contains important information. Adult assembly is required. Tools required for assembly: Phillips Screwdriver, Hammer and Scrap Block of Wood (not included). Age: 2-5 years Weight limit: 55 lbs (25 kg). www.fisher-price.
PAGE 2
Consumer Information WARNING CAUTION To avoid serious injury: • Adult supervision is required. • Never use near cars and other motor vehicles, near streets, steps, sloped driveways, hills, roadways, alleys, swimming pool areas or other bodies of water. • Always wear shoes or sneakers. • Never allow more than one rider. This product contains small parts in its unassembled state. Adult assembly is required.
PAGE 3
Assembly PUSH Seat Straight Axle Assembly 3 Frame 1 Bottom View • Turn the frame upside down. • Insert the straight axle assembly through the holes in the rear of the frame. • Fit the seat onto the frame. • Push firmly near the back end of the seat to "snap" it into place.
PAGE 4
Assembly Pedal Axle Tab Pedal Hub 7 Pedal Hub • Fit two pedal hubs onto the pedal axle tabs. Make sure the tabs fit into the slot in each pedal hub. • While holding the pedal hubs on the pedal axle, insert the pedal axle into the hole in the center of the front wheel. • Press the pedal hubs into the center of the front wheel until they are flush with the surface of the front wheel. • Repeat this procedure for the other two pedal hubs on the other side of the front wheel assembly.
PAGE 5
Assembly E Fork Post IK R FT R EA Handlebar Front O R Fork Post Handlebar Back ¾" Screw ¾" Screw 2¼" Screw 9 Fork Cover 10 • Insert the fork post up through the hole in the neck of the frame. Make sure the fork is positioned so that the fork covers face the rear wheels. • Fit the handlebar front to the fork post. Hint: The handlebar front is designed to assemble to the fork post one way. • Fit the handlebar back to the fork post and handlebar front. Hold them together firmly.
PAGE 6
Consumer Information Label Decoration • Periodically, check the plastic parts and if broken or cracked, dispose of them properly. • Periodically, check all fasteners regularly to be sure they are tight. If the fasteners are not tight, tighten them as necessary. • To clean, use a mild soap and water solution and a clean cloth. Rinse clean with water to remove soap residue. IMPORTANT! It is a good practice to start training children very young regarding the importance of helmet use.