Bounce ‘n Play Activity Dome Model Number: 79652 Please keep this instruction sheet for future reference, as it contains important information. Tool needed for assembly: Phillips Screwdriver (not included). Use only for a child who is unable to push up on hands and knees, pull up or sit unassisted. Product features may vary from picture above. w she ww.fi r-p .
Warnings Consumer Information WARNING Occasionally a consumer may experience a problem with one of our products. If this should happen, please call us toll-free, rather than return this product to the store. Usually, we can solve the problem over the telephone or send you replacement parts. Please call Fisher-Price® Consumer Relations, toll-free at 1-800-432-KIDS, 8 AM - 6 PM EST Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment, please call 1-800-382-7470.
Parts Metal Canopy Stay ® ® Pad 1 2 Covers 1 3 Toys (Toys may be different than shown.) 2 Base Wires Base Spring - 4 Plastic Mesh Cover Stay M5 x 113/16" Screw - 2 CAUTION M6 x 15/8" Screw - 8 This product contains small parts in its unassembled state. Adult assembly is required.
Assembly IMPORTANT! Before each use or assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed. Never substitute parts. Button Hole Frame Middle Hole Middle Hole Plastic Mesh Cover Stay Mesh Cover 3 Frame Tubes • Position the ends of the frame tubes against the middle holes in a frame.
Assembly Frame 5 • Tighten the screws with a Phillips screwdriver. Do not over-tighten. • Repeat assembly steps 3 - 5 to attach the other ends of the frame tubes to the frame on the other side of the base. 5 M6 x 1 /8" Screw - 4 7 Rounded Side • Fit an M6 lock nut (with the M6 Lock Nut - 4 rounded side toward the fabric) into each lower, hexagonal opening on the back of the frame. • Tighten the screws with a Phillips screwdriver. Do not over-tighten.
Assembly Toys Rounded Side Canopy Fasteners M5 x 113/16" Screw -2 M5 Lock Nut -2 Pad Fastener Metal Canopy Stay Cover 9 Upper Hole 8 Slot ® • Fasten the pad fasteners to the base fasteners. • Lift the canopy. • Attach the toys to the canopy fasteners. IMPORTANT! Assembly is now complete, but Bounce ‘n Play Activity Dome is not ready for use. Please refer to the Use instructions, on this page, beginning with step 2. Tab • Position one end of the metal canopy stay against the upper hole in a frame.
Use To Unfold PUSH PUSH Frame Groove 1 3 Base Wire Sides of Base Wire • Position the product upright on a flat surface. • Grasp both sides of a base wire. • Pull both sides of the base wire outward and then let the base wire rotate down. Note: If the base wire does not freely rotate down, pull the sides of the base wire further outward. • Push down on the product to be sure each side of the base wire is in the correct position. The base wire should rest in the groove in each frame.
Use Use Using the Mesh Cover Base Wire Zipper Mesh Cover Up Canopy Up 7 5 ® • Rotate the base wire up. • Repeat this procedure to fold the other base wire. • Adjust the canopy and mesh cover up. • While holding the mesh cover up, fasten the zipper closed. To Fold for Portability Care The pad and toys are machine washable. Wash the pad and toys separately in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly.