Deluxe Take-Along™ Swing Model Number: 79618 Please keep this instruction sheet for future reference, as it contains important information. Adult assembly is required. Tool needed for battery installation: Phillips Screwdriver (not included). Requires four “C” (LR14) alkaline batteries for operation (not included). Weight Limit: 25 lbs (11.3 kg). IMPORTANT! The maximum weight limit for this product is 25 lbs. If your child weighs less than 25 lbs.
Warnings WARNING • To prevent serious injury or death from falls and being strangled in the restraint system: - Always use the restraint system. - Never use with an active child who may be able to climb out of the seat. • Never leave child unattended. • Never use on any elevated surface. Consumer Information Occasionally a consumer may experience a problem with one of our products. If this should happen, please call us toll-free, rather than return this product to the store.
Parts Frame with Liner Pad with Restraint Front Tube 2 Frame Tubes 3
Assembly IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed. Never substitute parts. 1 Upper Frame Tube • Rotate the upper frame tube until it "snaps" into an upright position, as shown.
Assembly Lower Frame Tubes 3 Pull Front Tube • Check to be sure the front tube is secured to the lower frame tubes. • Pull the front tube. It should remain attached to the lower frame tubes. If you can remove it, you have not assembled it properly. Please re-read and repeat Assembly step 2. Frame with Liner Press Button on Upper Frame Tube Seat 4 Front Tube • Position the frame with liner so that the seat is over the front tube.
Assembly Frame with Liner Upper Frame Tube Upper Frame Tube 5 • Check to be sure the upper frame tubes are secure in the frame with liner. If you can remove the upper frame tubes from the frame with liner, you have not properly inserted the tubes into the frame. Remove the upper frame tubes from the frame with liner and reread and repeat Assembly step 4. IMPORTANT! This product must always be used with the pad provided, which includes the restraint system.
Assembly Waist Belts Slot 7 Slot • Lift the edges of the pad and insert the waist belts on the liner through the slots in the pad. Assembly is now complete.
Battery Installation Battery Compartment Door Battery Holder • Locate the battery compartment door on the frame. • Loosen the screw in the battery compartment door with a Phillips screwdriver. • Remove the battery compartment door and the battery holder from the battery compartment. Battery Holder • Open the battery holder. • Insert four "C" (LR14) alkaline batteries as indicated inside the battery holder. Hint: We recommend using alkaline batteries for longer battery life. • Close the battery holder.
Battery Installation Battery Holder Battery Compartment Door • Align the ridge on the battery holder with the groove in the battery compartment. • Slide the battery holder back into the battery compartment. • Replace the battery compartment door and tighten the screw with a Phillips screwdriver. Do not over-tighten.
Battery Safety Information 1.5V x 4 "C" (LR14) SHOWN ACTUAL SIZE Batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Remove batteries during long periods of non-use. Always remove exhausted batteries from the product. Dispose of batteries safely. Do not dispose of batteries in a fire.
Securing Your Child WARNING • To prevent serious injury or death from falls and being strangled in the restraint system: - Always use the restraint system. - Never use with an active child who may be able to climb out of the seat. • Never leave child unattended. • Never use on any elevated surface. Restraint Waist Belt Waist Belt 1 • Place your child in the seat. Position the restraint between your child’s legs. • Fasten both waist belts to each side of the restraint.
Securing Your Child Free End Free End Anchored End B B Anchored End 2 Loosen Tighten To tighten the restraint: • Feed the anchored end of the restraint belt up through the buckle to form a loop . • Pull the free end of the restraint belt B . • Repeat this procedure to tighten the other restraint belt. To loosen the restraint: • Feed the free end of the restraint strap up through the buckle to form a loop . • Enlarge the loop by pulling on the end of the loop toward the buckle.
Starting the Swing IMPORTANT! Before each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed. Never substitute parts. Power Dial Power Dial • Turn the power dial to any of eight settings. • Give the seat a light push to start the swinging motion. Adjust the swing power dial to the desired swing motion setting.
Lights and Music! Hint: Your baby can enjoy lights and music with or without swinging. Baby Activated Lights and Music Switch Parent Activated Volume Dial Lights and Music Switch • Slide the lights and music switch to: baby activated lights and one song ; sound and lights off ; or parent activated lights and music . When baby pulls either toy on the arch, one tune plays along with twinkling lights. When switched to this setting, six tunes (approximately 10 minutes) play along with dancing lights.
Room-to-Room Portability WARNING • To prevent serious injury or death from falls and being strangled in the restraint system, always use the restraint system. • Never use on any elevated surface. • Make sure your child is properly secured in the swing seat. • With baby facing forward and outward, lift the swing using the handle. • Carefully carry the swing to another room. Be sure to set the swing down on a non-elevated, flat surface.
Take-Along Seat Bottom Lift Seat Back Lift Seat Bottom 1 • Lift the seat back and seat bottom together. Straps Seat Back Press Tab Press Tab 2 • • • • Tip the swing backwards the seat back down. Unfasten the straps on the seat bottom. Pull the straps from the loops on the seat bottom. Press both tabs on the frame at the same time to release the frame base.
Take-Along Lower Frame Tube 3 • Rotate the lower frame tube around to the top of frame, as shown. Upper Frame Tube Strap 4 Lower Frame Tube • Fit the straps on the seat bottom between the upper and lower frame tubes, as shown. • Wrap the straps around the lower frame tubes and fasten the straps. To set the swing back up for use: • Unfasten the straps around the upper and lower frame tubes. • Replace the straps through the loops on the seat bottom and fasten.
Care • The pad is machine washable. Wash the pad separately in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly. The frame, liner and toys may be wiped clean using a mild cleaning solution and a damp cloth. Do not immerse the frame. • This product has no consumer serviceable parts. Do not take this product apart. IMPORTANT! This product must always be used with the pad provided, which includes the restraint system.
One (1) Year Limited Warranty Fisher-Price, Inc., 636 Girard Avenue, East Aurora, New York 14052 warrants that the Deluxe Take-Along™ Swing is free from all defects in material and workmanship when used under normal conditions for a period of one (1) year from the date of purchase. Should the product fail to perform properly, we will repair or replace it at our option, free of charge.
FCC Statement (United States Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.