Instruction Sheet

ManualsBrandsFisher-Price ManualsBaby Monitors79534

Bracket Kit Parts

Bounce ‘n Play Activity Dome

Bracket Kit

2 Brackets

Instruction Sheet

IMPORTANT! Enclosed are two brackets that will keep the suspended floor of this

product from tipping. Please follow these instructions carefully.

Installation Instructions

Bounce ‘n Play Activity Dome

Bracket Kit

l N

: 7

IMPORTANT! Enclosed are two brackets that will keep the suspended floor of

this product from tipping. Please follow these instructions carefully.

2 Barackets

Instruction Sheet

Bracket Kit Parts

Model Number: 79534

Installation Instructions

WARNING

Suffocation Hazard

• The straps supporting the product can fail and cause the floor to tip.

• Do not use this product until you have repaired it.

Suffocation Hazard

• The straps supporting the product can fail and cause the floor to tip.

• Do not use this product until you have repaired it.

Tool required for assembly: Phillips screwdriver.

Summary of content (6 pages)

PAGE 1
Installation Instructions Bounce ‘n Play Activity Dome Bracket Kit Model Number: 79534 WARNING Suffocation Hazard • The straps supporting the product can fail and cause the floor to tip. • Do not use this product until you have repaired it. Bracket Kit Parts Tool required for assembly: Phillips screwdriver.
PAGE 2
Bracket Installation 1 2 Frame Sides of Base Wire Groove Groove Sides of Base Wire • Lift the product up slightly so that each side of the base wire "snaps" into the groove in each plastic cover. Make sure you hear a "snap". • Position the product upright on a flat surface. • Grasp both sides of a base wire. • Pull both sides of the base wire outward and then let the base wire rotate down. Hint: If the base wire does not freely rotate down, pull the sides of the base wire further outward.
PAGE 3
Bracket Installation CAUTION 4 Please keep small parts, such as the screws and lock nuts, away from children. 3 Screw Pull fabric / floor board away from plastic covers. Front Plastic Cover Plastic Covers Upper Hole • With the product on its side, pull the fabric/floor board away from the plastic covers. This will allow you easy access to the back plastic cover. Lock Nut • Tip the product on one side. Hint: You may want to lean the product against a wall or object to steady it.
PAGE 4
Bracket Installation Bracket Frame Tubes 1" - 11/2" 5 Frame Tubes 1" - 11/2" 6 Hooked Tabs Press Back Plastic Cover Frame Tubes Frame Tubes Bracket Bracket Bracket Between Frame Tubes and Back Plastic Cover • Position a bracket so that the hooked tabs curve away from you. Hints: - Make sure the fabric/floor board is pushed away from the plastic covers. - Make sure the frame tubes are about 1" - 11/2" apart. • Fit the bracket behind the frame tubes.
PAGE 5
Bracket Installation 8 7 Lock Nut Protruding Side Screw Metal Canopy Stay Front Plastic Cover Back Plastic Cover Hooked Tab Bracket Lock Nut CORRECT IMPORTANT! When correctly assembled, the hooked tabs on the bracket wrap around the back plastic cover, as shown. • While positioning the metal canopy stay against the hole in the bracket, replace the screw through the front plastic cover, metal canopy stay, bracket and into the back plastic cover.
PAGE 6
If you have further questions regarding the installation of the brackets, please call Fisher-Price® Consumer Affairs, toll-free at 1-800-233-4004, 8 AM-5 PM EST Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment, please call 1-800-382-7470. Or, write to: Fisher-Price® Consumer Affairs, 636 Girard Avenue, East Aurora, New York 14052. Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A. ©2000 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S.