Sound ‘n Lights Monitor Model Number 71565 Please read these instructions and keep them for future reference. Includes two AC adaptors to power the transmitter and receiver. The receiver also runs on battery power (9v alkaline – not included).
A Consumer Information Occasionally a consumer may experience a problem with one of our products. If this should happen, please call us toll-free, rather than return this product to the store. Usually we can solve the problem over the telephone or by sending you replacement parts. Please call Fisher-Price® Consumer Affairs, toll-free at 1-800-432-KIDS, 8 AM - 6 PM EST Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment, please call 1-800-382-7470.
C Your Sound ’n Lights Monitor 16 6 3 11 2 4 17 19 10 13 5 OFF ON A B POWER CHANNEL OFF ON POWER A B 9 CHANNEL 14 12 ® Fisher-P rice Fisher-Price ® 7 1 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 18 8 Transmitter . . . . . . . . . . . . . . .Sends (transmits) sounds to the receiver. On/Off Switch . . . . . . . . . . . . .Turns the transmitter power “ON” or “OFF”. Power Indicator . . . . . . . . . . .Lights up to let you know the transmitter is “ON”. Microphone . . . . .
D • If a removeable rechargeable battery is used, it is only to be charged under adult supervision. • A rechargeable battery is to be removed from the product before it is charged. • If you use a battery charger, it should be examined regularly for damage to the cord, plug, enclosure and other parts. Do not use a damaged battery charger until it has been properly repaired.
• If you will be using the AC adaptor to power the receiver, unwrap and fully extend the AC adaptor cord for best reception. Insert the AC adaptor jack into the side of the receiver. • Insert the plug into a standard wall outlet. • Check to be sure the channel switch on the receiver is set to the same channel as the transmitter. • Slide the on/off switch on the front of the receiver to the “ON” position. The power indicator will light. • Adjust the volume by turning the volume dial to a comfortable level.
F Sound Reception I It is very important to test the sound reception of the Sound ’n Lights Monitor before first-time use and whenever you change the location of the transmitter. • Test the Sound ’n Lights Monitor transmission and reception. In the room you intend to use the transmitter, have an adult speak into the transmitter. (If an adult is not available,use a ticking clock or radio.) Place the receiver in the room in which you intend to use the receiver.
J Problems and Solutions Guide IMPORTANT! If you have a problem with the Sound ’n Lights Monitor, first check the Problems and Solutions Guide below. If you still experience a problem with the Sound ’n Lights Monitor, call Fisher-Price® Consumer Affairs, toll-free at 1-800-432-KIDS, 8 AM - 6 PM EST Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment, please call 1-800-382-7470. Or, write to: Fisher-Price® Consumer Affairs, 636 Girard Avenue, East Aurora, New York 14052.
PROBLEM Weak reception PROBABLE CAUSE SOLUTION Out of range or insufficient signal Test reception by moving the transmitter and/or receiver to different locations throughout the house. Relocate the transmitter and/or receiver. AC adaptor cord(s) not fully extended Fully extend AC adaptor cord(s). Improper antenna position Make sure antennas are pointing upward.