Instruction Sheet

ManualsBrandsFisher-Price ManualsToysFisher-Price 25771

(not included

(not included).

Keep these

instructions

for future

reference, as

they contain

important

information.

CONSUMER INFORMATION

(

800

)

524-TOYS

We are dedicated to quality products.

CONFORMS TO THE SAFETY

REQUIREMENTS OF ASTM F963.

MATTY MATTEL™ toys

YOU CAN TELL IT'S MATTEL!

™

CALL us toll-free

or write with any comments or questions about

our products or service. Monday-Friday, 8:00

a.m.-6:00 p.m. Eastern Time. Outside U.S.A., see

telephone directory for Mattel listing. Consumer

Relations, Mattel, Inc., 333 Continental Blvd.,

El Segundo, CA 90245 USA

Summary of content (4 pages)

PAGE 1
25771-0920 G2 BATTERY SAFETY INFORMATION: 1. Non-rechargeable batteries are not to be recharged. ¨ 2. Rechargeable batteries are to be removed from the product before they are charged. 3. If removable rechargeable batteries are used, they are only to be charged under adult supervision. 4. Do not mix alkaline, standard (carbon-zinc), or rechargeable ª (nickel-cadmium) batteries. 5. Do not mix old batteries and new batteries. 6. Only batteries of the same or equivalent type as recommended are to be used.
PAGE 2
10 Attach Labels and Accessories to tower. 2 1 INSTALL BATTERIES 3 4 TO REMOVE BATTERIES 5 6 OFF 8 7 ON Label sheet Open battery cover. Insert 4 "D" cell alkaline batteries (not included) as shown. Close battery cover. Turn power switch ON to play. TROUBLE-SHOOTING TIPS The playing surface is level and flat. All 5 1 & 4 TRACK and CURVE connections are joined together tightly. If set appears to run slowly, replace batteries with 4 fresh "D" size alkaline batteries.
PAGE 3
ASSEMBLY TIPS: Look for letters or numbers marked on the tower panels (as shown) for reference. 1 3 D Assemble 2 the back of tower. Set aside. Assemble the (E, F) front of tower. F Partially engage screws; 3 INSIDE RAIL of tower front, THEN align each panel to tighten screws to screw (A, B, C, D) C FOR EACH SIDE PANEL: 6 holes before adding next panel. E B 2 5 Assemble bottom panels first and work upward. A 1 4 4 Attach back of tower.
PAGE 4
7 IMPORTANT SAFETY NOTE FOR ADULT: Top Tower Curve must remain attached to the top of the Tower at ALL TIMES. Push curve in until it is FULLY SEATED and SNAPS in place. Attach the shields onto tower TRACK CURVE (teeth shield on the bottom). 8 Attach loops as shown. Snap top part of track into top of tower. 9 Attach face accessory on 2nd loop and teeth on bottom loop.