HEAT PUMP CLOTHES DRYER DH9060P & DH9060PG models INSTALLATION GUIDE NZ AU BI
SAFETY AND WARNINGS ! WARNING! Electric Shock Hazard Failure to follow this advice may result in electric shock or death. • If you are using an extension cord or a portable electrical outlet device (eg multi-socket outlet box), ensure that it is positioned so that it does not come into contact with water or moisture. SUPPLIED PARTS z z z Keep all packing materials until the unit has been inspected. Inspect the product to ensure there is no shipping damage.
PRODUCT DIMENSIONS D B C FRONT PROFILE A PRODUCT DIMENSIONS MM min 840 A Overall height* C e D max 855 B Overall width 600 C Overall depth** 665 D Depth with door open 1080 *Includes adjustable mounted feet and the range of movement **Includes dial and door when closed PLAN Actual product dimensions may vary by ± 2 mm.
CAVITY & CLEARANCE DIMENSIONS * Front panel of the product c B a c B a b b ISOMETRIC b FRONT PROFILE CAVITY DIMENSIONS MM CLEARANCE DIMENSIONS MM A Minimum cavity height 860 A Minimum door clearance to adjacent wall 335 B Minimum cavity width 640 C Minimum cavity depth z Flush with front panel of the product z In cupboard B Minimum side clearance to adjacent product or cabinetry* 20 *Applies to side, top and rear 640 705 Actual product dimensions may vary by ± 2 mm.
ELECTRICAL CONNECTION UNPACKING CONNECTION LOCATIONS / LENGTHS Drain Hose 1300mm Power Cord 1500mm 1 Remove the outer packaging including the plastic wrapping. 2 Lift the dryer off the base. 3 Remove all packaging and accessories from inside the drum. 4 Dispose of all packaging sustainably, ensuring these materials are kept out of the reach of children.
INSTALLATION OPTIONS Installation location z z z Do not install your dryer in such a way that the dryer door cannot be opened fully. Do not install the dryer outside, in a damp place, where there is a risk of freezing, where it may be rained on, in direct sunlight or close to a source of heat. Do not place your machine on top of its power cable. LEVELLING THE DRYER It is IMPORTANT to level the dryer to ensure the machine runs efficiently with minimal noise.
DRAINING The dryer is equipped with a condenser unit which accumulates water during the drying cycle. This water is either collected in the removable water tank located at the top left of the dryer, or you can setup your dryer to drain automatically using the drain hose provided. We recommend the dryer is set up to drain automatically where possible especially when drying full loads, this will avoid having to empty the water tank during a drying cycle.
COMPLETE INSTALLATION z z z Turn on the water and check all hose connections for leaks. Make sure there are no kinks in the hose(s). Check the hose connections for leaks again after 24 hours. Uncoil power cord, remove and discard the plastic pin cover, and plug into wall socket. Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
SPARE PARTS SPARE PARTS* Drain hose extension (not suitable for attaching to a spigot) PART NO. 425627P * Available from your Fisher & Paykel dealer or a Fisher & Paykel trained and supported service technician Complete and keep for safe reference: Model Serial No.
FISHERPAYKEL.COM © Fisher & Paykel Appliances 2021. All rights reserved. The models shown in this guide may not be available in all markets and are subject to change at any time. The product specifications in this guide apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time.
