By Firstech, Inc INSTALLATION AND USER’S GUIDE website: www.compustar.org © 2001 Firstech, Inc.
T A B LE OF C O NT E N T S FCC/ID Notice………………………………………………………………….. 2 Remote-Pager ……………………………………………………………………… 3 Remote-Pager Button Functions………………………………………………. 4 Using Your System…………………………………………………………………. 5 Alarm Mode…………………………………………………………………….... 5 Dual Stage Shock Sensor……………………………………………………… 6 Panic Mode………………………………………………………………………. 7 Auto-start Function……………………………………………………………… 8 Query Function………………………………………………………………….. 8 CompuGLO Back-Light Mode ………………………………………………..
F C C / I D Not i c e This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device.
This 5 channel transmitter that allows you to activate multiple functions by pressing a combination of 4 buttons on the unit in order to transmit signals. Press Buttons (II+III) for a ½ second to make your remote-pager mute. A vibration icon will appear continuously on the upper left-hand corner of your CompuGLO LCD indicating that you are in remote-pager mute mode.
3. 4. III IV 1/2 sec 1/2 sec Auxiliary Option 2 Query Function 5. 6. 7. 8. III III IV - 2 sec 2 sec 2 sec 2 sec Same as pressing ½ secs. Auto-start Function - on/off Trunk Release - on/off Panic Off 9. 10. 11. 12. 13. 14.
Press Buttons (I+II) for a ½ second to make your car siren mute when arming or disarming your vehicle. A car siren icon will disappear on the bottom left-hand corner of your CompuGLO LCD indicating that you are in car siren mute mode. Keep in mind that your car siren will still activate for all other modes (i.e. panic, alarm, shock sensor) regardless of whether or not your car siren is in mute mode.
Light impact to your vehicle will activate the first stage shock sensor and the car siren will chirp 4 times in addition to the parking lights flashing 4 times. The remote pager unit will beep and a vibration icon will appear in the CompuGLO LCD. Heavy impact to your vehicle will activate the second stage shock sensor and the car siren will chirp for 30 to 60 seconds and the parking lights will flash for 60 seconds. The remote-pager will be notified audibly and a hammer icon will appear in the CompuGLO LCD.
The engine will run 15 or 25 minutes (25 or 40 min for diesel) depending on preset options at the time of installation and then shut off. If your remote-pager has a problem starting the vehicle, CompuStar will try 2 additional times. If the engine does not start after the third attempt, please call your authorized CompuStar dealer. Diagnosing problems with Auto-Start If there is a problem in auto-starting your car, you will hear three chirps when you attempt to auto-start the car.
Press Button III for 2 seconds in order to unlock and release your trunk door. Note that the trunk release function will not only release the trunk but will unlock all the doors as well. Reservation Mode (manual transmission only) In order to auto-start your manual transmission car, you must first set the CompuStar system to Reservation Mode before leaving your vehicle. The purpose of Reservation Mode is to leave the transmission gear in the neutral position when you leave your vehicle.
after the reservation has been set. Once cancelled, you will have to start the vehicle with the manual key and repeat the above 5 steps if you want to restore reservation mode. Important! If you try to auto-start the vehicle when reservation mode has not been set or turned on, the auto-start feature will not work. When you press the auto-start button, the car parking lights will flash three times and the door icon in the CompuGLO LCD will be flashing to inform you that reservation mode has not been set.
In order to enter Valet mode, press Buttons (I+III) simultaneously for a ½ second or insert the key into the ignition and turn the ignition on and off five times within 10 seconds. The remote-pager CompuGLO LCD will display a ZZZ icon indicating that you are in Valet Mode. In order to exit Valet Mode, press Buttons (I+III) simultaneously for a ½ second. Timer Start Mode In Timer Start Mode, your car automatically starts every 1.
Most likely, you did not push Button II for the required 2 seconds. Pushing Button II for only a ½ second engages the optional auxiliary function instead of auto-start. Another reason maybe that you are in Valet Mode. If there is a ZZZ icon on your remotepager unit, you are in this mode and all the functions of the CompuStar 2WSSR are disabled except for keyless entry. Press Button (I+III) simultaneously for a ½ second to deactivate Valet Mode.
Step 1: Remove the AA battery from the remote. Step 2: Activate Valet/Programming mode by manually turning the ignition on and off five times with car key within a 10 second period which is the technically similar to giving the Green wire 12V pulse five times. The parking light will flash once with successful completion of this step. Step 3: Within a 6 second period after cycling the ignition for the 5th time, Insert the batter back to the remote.
If you hear a long chirp, you are going out of programming mode, please go back to Step 1. If you want to change more options, go back to Step 1. Resetting the Programming Options to the factory default settings. Step 1: Press Buttons (I+II) simultaneously or Buttons (I+III) simultaneously for 2 seconds. Step 1 is confirmed by a car chirp and a one-time flashing of the parking light. Step 2: Press Button III three times.
1-7 Turbo OFF ON Programming Menu #2 (Security Options) Feature Factory Default Setting – Button I Optional Setting – Button II 2-1 Cold Start with Temp Sensor OFF ON 2-2 Timer Start or Minimim Interval between Cold Starts 3 Hr 1.5 Hr 2-3 Passive Arming Passive Locking, too No Passive Locking 2-4 Anti-jacking OFF ON 2-5 Ignition Controlled Door Lock OFF ON 2-6 Aux 1 Output .5 sec Latch 2-7 Aux 2 Output .5 sec Latch 2-8 Siren Duration 30 sec 60 sec © 2001 Firstech, Inc.