N99J2WFMRS Two-Way FM Remote USER’S GUIDE By Firstech, Inc. Website: www.compustar.org © 2001 Firstech, Inc.
Safety Information Please take these safety precautions under the following conditions: 1. Servicing the vehicle When servicing (i.e. changing the oil, washing your car) your automobile, the CompuStar system should be in Valet Mode. There is a safety shutdown switch under the hood that deactivates the remote starter function if the hood is open.
Remote-Pager Button Functions 1. 2. 3. 4. Button I II III IV Pressed For 1/2 sec 1/2 sec 1/2 sec 1/2 sec Function Lock/Unlock Auxiliary Option 1 Auxiliary Option 2 Query Function 5. 6. 7. 8. III III IV - 2 sec 2 sec 2 sec 2 sec N/A Auto-start Function - on/off Trunk Release – on/off N/A. 9. 10. 11. 12. 13. (I+II) (I+III) (II+III) (II+IV) (III+IV) 1/2 sec 1/2 sec 1/2 sec 1/2 sec 1/2 sec N/A Valet Mode – on/off N/A Timer Start Mode - on/off Turbo Mode - on/off 14 16. 17.
2. 3. 4. 5. 6. 7. 8. 9. 10.
Auto - Start Function Press Button II for 2 seconds to auto-start an automatic transmission engine. Remember that a manual key in the ignition is required to drive the car. In addition, the anti-grind circuit (this maybe an optional feature provided by your installer) prevents you from re-cranking the starter on a remote-started vehicle. Press Button II for 2 seconds in order to turn off an auto-started car. For manual transmission vehicles, please use reservation mode.
In order to auto-start your manual transmission car, you must first set the CompuStar system to Reservation Mode before leaving your vehicle. The purpose of Reservation Mode is to leave the transmission gear in the neutral position when you leave your vehicle. Reservation mode is intended for use in MANUAL TRANSMISSIONS ONLY and NOT FOR AUTOMATIC TRANSMISSIONS. Reservation Mode must be engaged each and every time you leave your manual transmission car in order to auto-start the vehicle.
later, the cause for the error will be indicated by the number of times the car chirps and parking lights flash. See Page __ for error messages. Canceling Reservation Mode If you do not want to set reservation mode, shut off the engine before you exit the vehicle. The engine will shut off for the following reasons: • You did not activate the parking brake or press the foot brake when you turned the manual key to the off position. • You released the parking brake while the engine was running.
Query Function Query Function allows the owner to visually monitor the status of your car. Press Button IV for a ½ second to activate the Query Function. Status of Car Lock, Engine Off Unlock, Engine Off Lock, Engine On Unlock, Engine On Parking Light Flash Once Twice Three Times Four Timess Valet Mode The only feature operating in valet mode is the keyless entry function and optional auxiliary functions. Valet Mode is very useful when washing your vehicle or having it serviced.
In Timer Start Mode, your car automatically starts every 1.5 or 3.0 hours depending on preset options during the time of installation for a 24-hour period. This mode is deleted automatically after 24 hours or once you start your car with either your manual key or remote. In order to enter Timer Start Mode, press Buttons (II+IV) simultaneously for a ½second. Also, note that Timer Start Mode becomes Cold Start Mode once an optional temperature sensor is installed.
You can turn this function on or off by pressing Buttons (II+III) for a ½ second . When set to passive locking, your system will lock automatically 30 seconds after all the car doors are closed. Turbo Mode If this optional Turbo Mode has been programmed at the time of installation, you can turn this feature on and off by pressing Buttons (III+IV). Under this mode, engine continues running for 2 minutes after key has been taken out from the ignition if emergency brake was on when the key is taken out.