FB155BC Version 2.0.0 6 PRELIMINARY PRODUCT COMPONENTS The preliminary value of product is set as on the
. Please be sure of basic set value and so on before using the product. TYPE SET VALUE Device Name FB155v.x.x.FB155BC Version 2.0.
FB155BC Version 2.0.0 8 How to Complete PC Configuration The following PC Configuration shall be explained on the assumption that FB155BC is connected with PC Interface Board(Jig board). If it is connected to MICOM, then you can change the set value by using AT command language with reference to Attachment AT command language. Components for PC Configuration - FB155BC module - PC Interface Kit The PC Configuration could be processed with two significant ways.
FB155BC Version 2.0.0 (4) Select “CONNECT”( Blue Lined) on the main display. 1 Select Product : Name of Product in Use 2 DEBUG CHAR : Default is 0x02.
FB155BC Version 2.0.0 1 Serial Connection, Ready To Set : Show the connection status of Config tool and products 2 Status Message : Display the status of command language in progress (6) After the product and config tool is connected properly, select CONFIG button(blue lined box) on Figure<8-3>, display like will comes up to allow to configure the environment. 1 PC Configuration Window : Allow to select the PC configuration value of the product.
FB155BC Version 2.0.0 2 Status Value : Output the status value with the form of message. 3 Status of Command Language : Since the preliminary operation method is to use AT command, the progressed AT command language will output in the form of message. 1 READ STATUS Button : To read in the PC configuration set in the product.
FB155BC Version 2.0.0 8-2 PC Configuration using Serial Communication(Hyper Terminal) Program 8-2-1 To execute Hyper Terminal To set up PC configuration using Hyper Terminal, following works will have to be done before power is authorized to the PC connected with the product. To accomplish the PC configuration, serial communication program is required. Here Hyper Terminal will be used for explanation.
FB155BC Version 2.0.0 (3) When Registration Information Window comes up as on , select Bit per second : 9600, Data bit : 8, Parity : none, Stop bit : 1, Flow control : none, which will execute Hyper Terminal. (4) Basically, the Hyper Terminal does not show the entered character.
FB155BC Version 2.0.0 entered character, select [File]Æ[Properties] on the Menu, then registration information window will appear shown as on , click the ASCII Setup button. (5) As shown on , “Check Echo typed characters locally” and come out pressing the acknowledge button. Now the Hyper Terminal program setting procedure is completed to use PC Configuration.
FB155BC Version 2.0.0 (6) To turn on the FB155BC from the condition which presses FA_SET button is PCconfiguration. As , there will be PC-configuration message in Hyper-Terminal.
FB155BC Version 2.0.0 8-2-2 How to Use PC Configuration Menu The user will select the menu want to change. To select the menu, you may just select the number given on the left side. For example : To change “DEVICE NAME”, enter : [“0”]Æ[Enter] Note : At condition, Pressing FA Set button for more than 2 seconds will reset all the configured values to the initial status (factory preset status). Following is the order to use the menu.
FB155BC Version 2.0.0 To satisfy FCC exterior labeling requirements, the following text must be placed on the exterior of the end product. Contains Transmitter Module FCC ID: U8D-FB155BC-F CAUTION: This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter. End users cannot modify this transmitter device. Any unauthorized modification could void the user’s authority to operate this device.
