Upgrade Upgrade FWC2050 Firmware You can install a new version of the FWC2050 software using the Firmware Upgrade page. You have a choice of three methods. You can use a local file, or FTP or TFTP to access a remote file. You can also set the upgrade to occur immediately, or at a scheduled time. Go to the Firetide Web site (www.Firetide.com) customer service downloads section to get new versions of the FWC2050 software. Includes AP firmware.
Backup/Restore Backup: Allows you to save the settings of the FWC2050 to a file. Restore: Configures the FWC2050 to the settings previously saved. Reboot/Reset Both Controllers and Access Points can be rebooted or reset to factory parameters. Remote Management Session Timeout You can specify a time period for automatic disconnect if the management connection remains idle.
Logs & Alerts Numerous Log Types are available. System Alerts Log Shows logged events. The results can be filtered. RF Events Log Shows logged RF events.
Load Balancing Shows occurrences of load balancing among APs. Rate Limit Events Shows occurrences of rate-limit events on clients using excess bandwidth.
Saving Logs Logs from individual APs and the FWC2050 Controller can be saved. AP Logs Select an AP to save a log of events associated with it. You will be prompted to enter a file name and select a location. System Logs You will be prompted to enter a file name and select a location.
Planning Coverage The FWC2050 can analyze coverage of your access points. Select a group of access points and use the sliders to specify the minimum acceptable coverage quality The analysis will tell you how many additional access points you need to provide hte specified coverage. It will also show you a map of suggested locations. In some cases, coverage gaps can be fixed by moving access points.
Appendix A Access Point Specifications Common Specifications Model 4100 4200 5100 5200 Use Indoor, Worldwide, 2.4/4.9/5 GHz Outdoor, Worldwide, 2.4/4.9/5 GHz Indoor, Worldwide. Radio 1: 2.4, Radio 2: 5 GHz Outdoor, Worldwide, Radio 1: 2.4, Radio 2: 5 GHz Bands 802.11a 802.11n (5100/5200 only) 802.11b/g 802.11n (5100/5200 only) Frequency (GHz) 5.15-5.25 5.25-5.35 5.725-5.825 4.9-5.090 4.94-4.990 5.470-5.725 2.412-2.484 Bands (GHz) 802.11a 5.725-5.825 UNII-3 802.11n (5100/5200 only) 5.470-5.735 UNII 5.
4000 Series Common Specification 5000 Series Common Specifications Bands (GHz) 802.11a, 5.725-5.825 UNII-3 Bands (GHz) 802.11a 5.725-5.825 UNII-3 802.11n 5.470-5.735 UNII 5.25-5.36 UNII-2 5.15-5.25 UNII-1 802.11b 802.11g 802.11n 5.470-5.735 UNII 5.25-5.36 M UNII-2 5.15-5.25 UNII-1 802.11b 802.
Appendix B FWC2050 Specifications Physical Specifications • Four GigE 10/100/1000 Mbps Ethernet ports with LEDs • IEEE 802.3, 802.3u compliant • CSMA/CD 10/100 autosense Network Ports Enclosure • LEDs (power, 2.4 GHz, 5 GHz) • Reset button (recessed) • Weight: 2 lb 14 oz (1.3 kg) • Dimensions 9.4” X 5.9” X 1.6” Power • DC Input: 12 VDC, 2.5 A • Port 1: IEEE 802.
Appendix D Regulatory Notices FCC Part 15 Note These devices comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference. • This device must accept any interference received, including interference that may cause undesired operation. FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
Appendix E Limited End User Product Warranty Pursuant to all provisions described herein, Firetide hardware products and Firetide antennas are warranted for one (1) year from the date of purchase against defects in the build materials and workmanship. Firetide does not warrant that the Products will meet any requirements or specifications of any End User Customer. This warranty applies to the entire Firetide product, including the AC power adapter.
Firetide, Inc. 140 Knowles Avenue Los Gatos, CA 95032 USA Copyright Notice: ©2010 Firetide, Inc. All rights reserved. Trademarks: Firetide, the Firetide logo, Instant Mesh Networks, HotPort, HotPoint, and HotClient are trademarks of Firetide, Inc. All other trademarks are the property of their respective owners.