User's Manual

Page 1

FinchShift 6DoF VR/AR controller and armband user manual

Installing the power source (batteries)

● Take the controllers and armband modules out of the box. To carry out the next steps,

you need 3 AAA batteries.

● Take the controller and open the battery slot by pressing on the lid and sliding it to

the side.

● Extract the battery compartment.

● Install two batteries as described on the lid, making sure each pole of the battery is in

the assigned position (the “+” pole is to be placed in the region with the greater

circumference described in the diagram, whereas the “-” pole is assigned to the

region with the smaller circumference). Return the battery compartment to its initial

position.

● Take the armband module and open the battery slot by pressing on the lid and sliding

it to the side.

● Insert a single battery as described in the diagram of poles on the lid of the module.

● Close the battery compartment.

Ensuring the correct setup of the power source

● To ensure that the batteries were installed correctly, the following steps must be

carried out

● For the controller:

○ Take the controller and hold the home button down for 2-3 seconds to turn on

the device. If the batteries were installed correctly, the controller should

vibrate briefly and an indication of the device being powered on should

appear (the LED lights in the controller will light up white)

● For the armband module:

○ Take the armband and hold the home button down for 2-3 seconds to turn on

the module. If the batteries were installed correctly, the controller should

vibrate briefly and an indication of the device being powered on should

appear (the LED lights in the controller will light up white).

Connecting the controllers to the smartphone

● Launch the FinchShift 6-DoF Demo

● One by one, activate all four devices of the FinchShift set by holding down the oval

button for 2-3 seconds. Bring all four devices as close to the headset as possible.

● Wait for all four devices to automatically connect to the smartphone (the Bluetooth

menu displays the connection status of each device). Make sure that the connection

indication is correct (all LEDs on the devices should be lit up white)

● If all is correct, the controllers and armband modules are ready for use

● If the automatic connection described in Step 3 does not occur after 20 seconds,

close the application and repeat all the steps once again

Putting on the devices

PAGE 1
Page 1 FinchShift 6DoF VR/AR controller and armband user manual Installing the power source (batteries) ● ● ● ● ● ● ● Take the controllers and armband modules out of the box. To carry out the next steps, you need 3 AAA batteries. Take the controller and open the battery slot by pressing on the lid and sliding it to the side. Extract the battery compartment.
PAGE 2
Page 2 Armband modules ● Take a FinchShift™ armband module ● Put on the armband module as such that the module is five centimeters above the elbow and that the oval button is facing towards the user’s head ● Secure the module using the Velcro’s, so that the armband module sits tightly on your arm. For the most comfortable experience, make sure that the Velcro is attached in the direction of the user’s body.
PAGE 3
Page 3 FCC Regulations: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device , pursuant to Part 15 of the FCC Rules.