Installation Instructions

Brief introduction:

(1) Output 1: 5V/1A

(2) Output 2: 5V/2A

(3) Micro USB Input: 5V/2A

(4) Type C Input: 5V/2A

(5) Power button ON/OFF (Switch Button)

(6) Wireless Charging Output Area

(7) LED display to show battery capacity

Use Operation:

Charge other device

(a) Use a suitable cable to connect the power bank and other device together to charge

(*Remarks: This charged device is suitable for 5V charge voltage)

(b) Before the 1

use, suggest to fully charge power bank at first.

center place to make sure the wireless charging is high efficiency.

Charge power bank

(a) Use the Micro USB Cable or Type C Cable to connect power bank and 5V adaptor(or

computer or other power sources) to charge power bank

(b) During charging power bank, LED display is flashing: it will display from 1%-99%. After fully

charged, LED light will stop flashing and become 4 LED lights always on.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation

PAGE 1
Brief introduction: (1) Output 1: 5V/1A (2) Output 2: 5V/2A (3) Micro USB Input: 5V/2A (4) Type C Input: 5V/2A (5) Power button ON/OFF (Switch Button) (6) Wireless Charging Output Area (7) LED display to show battery capacity Use Operation: Charge other device (a) Use a suitable cable to connect the power bank and other device together to charge (*Remarks: This charged device is suitable for 5V charge voltage) st (b) Before the 1 use, suggest to fully charge power bank at first.
PAGE 2
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.