User's Manual

To start using Fibaro System Home Center 2, please connect the device to power

and LAN sockets, as shown below.

1. Unscrew left side panel

3. Connect wires as shown on gure below

2. Take side panel o

HC2 back HC2 front

WARNING! Do not turn Home Center 2

on without RECOVERY pendrive.

PAGE 1
To start using Fibaro System Home Center 2, please connect the device to power and LAN sockets, as shown below. 1. Unscrew left side panel HC2 back 2. Take side panel off HC2 front 3. Connect wires as shown on figure below WARNING! Do not turn Home Center 2 on without RECOVERY pendrive.
PAGE 2
4. Connect HC2 6. Login to Home Center 2 Connect power cable to the mains, and network cable to LAN socket in your router (Home Center 2 requires an outside router). Go to www.fibaro.com, find Support section, download and install HC2 Finder designated for your operating system. 5. Start Home Center 2 Start HC2 with a POWER button and wait approx. 2 minutes for the device to start. Correct connection will be signalled by diodes 1, 2, 3 (see the glossary below). Start the HC2 Finder and click "Refresh".
PAGE 3
FCC ID: 2AA9MHC2 THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.This device must accept any interference received, including interference that may cause undesired operation.