Main User Interfaces Earphones L Left earphone (slave) R 2 2 1 1 Right earphone (master) 3 4R 3 4L 5 4L Touch control(slave) 1 Earwing 4R Touch control (master) 2 LED indicator 5 Microphone 3 Eartip Charging Case 6 7L 7R 8L TRUE WIRELESS EARPHONES USER MANUAL 9 8R 6 Charging Case Cover 8L Charge indicator(slave) 7L Left earphone (slave) 8R Charge indicator(master) 7R Right earphone(master) 9 Micro USB connector 4
Get Started Bluetooth Pairing Bluetooth pairing For first usage of brand new FIIL T1, please refer to page5“Get Started”, the earphone status indicator will continue to blink blue once entered pairing mode. To begin a new bluetooth pairing, please press and hold the master earphone (right earphone) until the LED indicator blinks blue. Search Connection Enter setup menu of audio source devices, select“search device”in “Bluetooth”then select“FIIL T1”in the device list to connect.
Bluetooth Sync Auto-Sync Please refer to page5“Get Started”, the left and right earphones will automatically get synced after Step2. How to Control User Interface Manual Sync 1st Step Place the earphones into charging case , press and hold both earphones untill power off (LED indicates red then off). 2nd Step Press and hold both earphones again untill their LED indications light purple. 3rd Step Close charging case then open again, the earphones will automatically get synced with flashing purple LED.
How to charge How to charge Charge earphone When earphone reminds“recharge headset”or the LED indicator blinks red , that means battery is low and earphone should be charged. Place the earphone into charging case and close, then earphone will be charged. *Notes: Earphone will power off during charging, so the left earphone (slave) can not be singly used if right earphone is being charged.
FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.