User Manual

Table Of Contents

FCC statement

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation if this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one of the following measures:

● Reorient or relocate the receiving antenna.

● Increase the separation between the equipment and receiver.

● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

To assure continued compliance, any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment. (Example-use only

shielded interface cables when connecting to computer or peripheral devices).

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference. and

(2) This device must accept any interference received, including interference that may cause

undesired operation.

This symbol on the product or in the instructions means that your electrical and electronic equipment should

be disposed at the end its life separately from your household waste. There are sparate collection system for

recycling in the EU.

For more information, please contact the local authority or your retailer where you purchased the product.

4. Replace the new batteries

Please replace a pair of new batteries and follow the previous instructions. (2, 3)

The blue LED on the wheel bar of the mouse is a low batteries power indicator. It

indicates that batteries inside the mouse need to be replaced.

Note

(6) When the battery power is low, the mouse's performance or the trans mission distance may not

be good. Please replace the new battery.

User's Guide

Wireless

Optical Mouse

PAGE 1
4. Replace the new batteries Please replace a pair of new batteries and follow the previous instructions. (2, 3) Note The blue LED on the wheel bar of the mouse is a low batteries power indicator. It indicates that batteries inside the mouse need to be replaced. Wireless Optical Mouse (6) When the battery power is low, the mouse's performance or the trans mission distance may not be good. Please replace the new battery.
PAGE 2
Introduction Congratulations on your purchase of the most innovative wireless optical mouse. With an incredible sensitivity to surface details and high tracking speed than other mice, the mouse can track reliably even on tricky polished or wood-grain surfaces. It offers even more advance that will make you more productive and more comfortable. + - 2 AA batteries Features 2.4GHz RF (distance 6~8m) Using state-of-art technology. High tracking speed and sensitivity.