FS-GM101 User's Manual Favite Inc.
Table of Contents CHAPTER 1 .......................................................................................................................... 3 Introduction ........................................................................................................................ 3 RFID Reader Module Overview ........................................................................................... 3 EPC Class 1 UHF RFID Tags ...........................................................................
CHAPTER 1 Introduction This Hardware Guide provides instructions of the FS-GM101 RFID Reader module. This document is designed for use by RFID system integrators. RFID Reader Module Overview The FS-GM101 is embedded with Phychips PR9000 chip and compliant with EPC Class1 Gen2 / ISO 18000-6C. The FS-GM101 supports one antenna port for bi-static configuration on RFID reader. The RFID Reader module is delivered with the following components: One (1) RFID Reader Module.
CHAPTER 2 Specifications System Host Interface UART / ISP(In-System Programming) Chipset PHYCHIPS PR9000 Operating Voltages 4.5V~5.
Mechanical: Reader Physical Size 29.5mm 30.6mm 11.5mm 3.
Antenna and IO Port Terminal Interface Antenna Port I/O Port PIN1 PIN8 Figure 2 – FS-GM101 I/O connector Pin no.
Select mounting position for antenna CAUTION: Reader antenna should be positioned so that personnel in the area for prolonged periods may safely remain at least 23 cm (9 in) in an uncontrolled environment from the antenna’s surface. See FCC OET Bulletin 56 “Hazards of radio frequency and electromagnetic fields” and Bulletin 65 “Human exposure to radio frequency electromagnetic fields.
FCC statement in User’s Manual (for class B) “Federal Communications Commission(FCC) Statement” This Equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC rules. These Limits are designed to provide reasonable protection against harmful interference in a residential installation.
USERS MANUAL OF THE END PRODUCT: In the users manual of the end product, the end product, the end user has to be informed to keep at least 23cm separation with the antenna while this end product is installed and operated. The end user has to be informed that the FCC radio‐frequency exposure guidelines for an uncontrolled environment can be satisfied.