Use and Care Manual

FAUX EZ™ (Original)

Directions for Use

May be used on:

Any existing soundly adhered, nearly white interior primed/sealed surface such

as painted wood, metal and vinyl coated cabinets etc. in good condition.

Product Coverage:

Step One liquid brush-on base coat:

8oz. liquid base covers about 20 square feet.

Step Two Aerosol

16 oz. aerosol covers about 20 square feet for light colors like oak or pine. Use

addition Step Two for darker colors such as Walnut or Mahogany.

Things you will also need:

1. Krud Kutter or TSP

2. Blue tape and paper

3. Cleaning sponge

4. Sanding sponge

Also see video on Directions for Use.

PAGE 1
FAUX EZ™ (Original) Directions for Use May be used on: Any existing soundly adhered, nearly white interior primed/sealed surface such as painted wood, metal and vinyl coated cabinets etc. in good condition. Product Coverage: Step One liquid brush-on base coat: 8oz. liquid base covers about 20 square feet. Step Two Aerosol 16 oz. aerosol covers about 20 square feet for light colors like oak or pine. Use addition Step Two for darker colors such as Walnut or Mahogany. Things you will also need: 1. 2. 3. 4.
PAGE 2
Surface Preparation: DO NOT USE STEEL WOOL! 1. Sand rough surfaces until smooth. If surface is already smooth, no sanding is required but surface must be cleaned with Krud Kutter or TSP and rinsed well. 2. Fill holes and caulk as needed and sand smooth again. 4. Tape off adjoining areas within spraying distance, (about 4 feet) and cover floors and ceiling. Applying FAUX EZ™: 1. Stir contents of liquid ‘Step 1’ thoroughly. 2. Apply ‘Step 1’ using your chip brush, leaving streak marks on the finish.
PAGE 3