User's Manual

1
DOG AGILITY SOFTWARE VERSION 1.0
AKC OR CKC VENUE
Standard & JWW Classes Setup Procedure
With the Timer stopped, press SETUP to open the menu
Press ENTER to select Dog Agility Rules
Press ENTER to select AKC or CKC RULES
Press ENTER for STANDARD COURSE TIME
Key in the STANDARD COURSE TIME using the numbers in the lower left hand corner of each keypad key
HINT: Press and hold the clear key to reset the time to “0" in the event you put in the incorrect time
Press ENTER after you have selected the correct time
HINT: The Maximum Course Time will automatically be set at 1.5 times the Standard Course Time per AKC and
CKC Rules
Press ENTER for Faults/Second
Default is preset at 1 Fault/Second. If you do not have computer scoring, this can be set at 1 Fault/Second for
Novice, 2 Faults per second for Open or 3 Faults/Second for Excellent to calculate Time Faults.
HINT: Press NEXT CHOICE on the Keypad to pass any menu choice that does not need to be set or reset
Press ENTER to Set Finish Eye
Press Enter the Finish Eye Menu
If the last obstacle is not used on course as any other obstacle, select Stop on Pass 1
If the last obstacle is used once on course before the last jump, press NEXT CHOICE and select Stop on Pass 2
If the last obstacle is used twice on course before the last jump, press NEXT CHOICE twice and select Stop on
Pass 3
HINTS:
1 - Press SETUP at any time to exit the SETUP mode
2 - An asterisk will identify the selected mode - e.g. *AKC Rules or *Stop on Pass 1
3 - All parameters can be updated individually and in any order desired
4 - All changes are automatically stored in the timer until changed again in the future
Operating Procedures for Human Timer
Verify that the eyes are adjusted to the correct jump height at the beginning of the class and with each jump height change.
Assuming everything goes normally, the time will automatically start and stop - simply show the time to the scribe to copy
down. If the time does not start, press the HORN key to stop the run before the third obstacle.
If a dog takes the last obstacle out of sequence or if the Timer stops in error, press RESTART on the keypad to resume
timing as if the timer had never been stopped.
If a dog is excused or fails to complete the course, press the START/STOP key to stop the time and report “no time” to the
scribe.
HINTS:
1 - There is no need to clear the time after each run.
2 - If a closed tunnel or a broad jump is the last obstacle, the timer will need to stop the time manually with the
START/STOP key when the dog crosses the finish line.
3 - Use the PREV & NEXT keys to scan back and forth through previous times - this can be done and viewed in the lower
window even while a dog is running.