i56A Indoor Station Quick Installation Guide
1 Package Contents i56A Indoor Station Quick Installation Guide www.fanvil.
2) Interface description There are some interfaces on the back of the device for connecting power supply, alarms etc. The connections are as follows: ② ③ ① ④ ⑤ No. Description 1 1 set of RS485 interface: can be connected to card reader, sensor etc. 2 2 sets of short-circuit output interfaces: corresponding to the short-circuit input interface, login device webpage settings, can be connected to electric locks, alarms etc.
95.00 84.00 65.50 4.20 3 Installation(two models) 50.30 15.50 47.50 12.2 74.80 106.00 125.50 Wall bracket Desktop bracket Model 1. Wall-mounted Installation Step 1. Install wall bracket Without 86 embedded box in the wall A. According to the position of the cable in the wall, dig out a square hole (height*width*depth=65.5*50.5*50mm) that can accommodate all cables. B.
Model 2. Desktop Installation Align the slot on the rear side of the panel with the pin on the desktop bracket and slide the bracket up to complete the installation. 4 Searching IP address There are two methods as shown below to search the device. The default WAN mode is DHCP. Method 1: After booting, click “Settings”---“Common” to query. Method 2: After booting, pull down the notification bar to query.
Step 3: Feature Setting Step 4:Unlock Setting Application——Door phone Settings——Add——OK. Title: Door Phone mode. Number: The SIP account of Door Phone. Line: The SIP line of Indoor Station. Access codec: Consistent with the access code in door phone access table (The i56A as calling party) Password: Same as open the door phone’s password (The i56A as called party) 6 Local Operation 6.1 Answer/hang up calls When the door phone calls the indoor station, click the the button to hang up the call. 6.