i51W&i52W&i53W Indoor Station Quick Installation Guide i51W i53W
1 Package Contents i51W&i52W&i53W Indoor Station Quick Installation Guide i50W i51SW Indoor Station Quick Installation Guide Wall-mount Bracket 10 pin Cable*1 4 pin Cable*1 2 pin Cable*1 TA4*30mm Screw*2 PM4*16mm Screw*2 Screw fixing seat*2 2 Physical specification PoE Wi-Fi (2.4G) RS-485 4.3” √ √ √ 163x104x26mm 7” √ √ √ 176x140x26mm √ √ √ 176x140x26.
No. Description No. Description 1 Management Center Key 4 Return / Hang up key 2 Monitor key 5 Answer key 3 Unlock Key 6 Microphone 2) Rear Panel ② ① ⑥ ③④⑤ No. Description 1 DC Power interface:12V/1A input. 2 Ethernet interface: standard RJ45 interface, 10/100M adaptive, it is recommended to use CAT5 or CAT5E network cable. 3 Industrial power interface. 4 1 set of RS485 interface: can be connected to card reader, sensor etc.
3) External device connection diagram 4 Installation Diagram(two models) Wall bracket Desktop bracket(Buy independently) Model 1. Wall-mounted Installation Step 1. Install wall bracket Without 86 embedded box in the wall A. According to the position of the cable in the wall, dig out a square hole (height*width*depth=58.5*60*50mm) that can accommodate all cables. B. Align the square hole of the wall bracket with the hole digged out before, then mark the two fixation holes through bracket on the wall. C.
With 86 embedded box or Dual gang box in the wall A. Make sure all cables in the embedded box . B. Fix the wall bracket on the 86 embedded box with two PM4*16mm screws. C. Fix bracket to Dual Gang Box with 4 PM3.3*20.5mm screws PM4*16mm Screw PM3.3*20.5mm Screw Step 2. Connect peripherals A. If you need to connect other input and output devices, please connect to the host through the cable. Step 3. Power on the device.
i51W i51W Method 2: i51W&i52W: After booting, long press the unlock key to enter the menu, click "System Message" --- "Network". i53W : After booting, “Menu”--- "Status". 6 IP Indoor Station Setting Step 1: Log in the web setting page of Indoor Station Input IP address of indoor station (e.g. http://172.18.70.55) into the address bar of PC’s web browser. The default user name and password are both admin. Step 2:Add the SIP account.
Step 3: Feature Setting Step 4:Unlock Setting Function Key--- Set unlock key type to "DTMF", and value is the password to open the correct access control device. 7 Local Operation Answer/hang up calls When the door phone calls the indoor station, click the and click the key to hang up the call. Unlock the door During the call of indoor station and door phone, click the key to answer the call, key to unlock the door.
FCC Statement This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received; including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.