USER MANUAL FOR $P V1.1 SERVO PROGRAMMER Fry System Requirements 1 Operating Voltage: USB 2 Operating System: Windows Windows Vista Windows 7/ Windows 8/ Windows 10 (32/64bit). 3 Application: Far torn Racing servos marked with Programmable’ Software Menu Instructions ¥ Programmable Serve The upper section of the software window is the information display.
USER MANUAL FOR $P V1.1 SERVO PROGRAMMER RATE Parameter Function Instruction. Servo Angle: Sets the derv rotation Angie. Serve Neutral: Sat the serve neutral position, OTE With the Transmitter set In the neutral position, if the serve Is not in the corresponding neutral position, this value can be changed to adjust the servo hom position.
USER MANUAL FOR $P V1.1 SERVO PROGRAMMER RATE Level Z: Sets the starting time and power value of the secondary protection. Level 3: Sets the starting time and power vas of the tertiary protection. NOTE: The left side Is to set the protection starting time.
USER MANUAL FOR $P V1.1 SERVO PROGRAMMER RATE sage Instructions Download programmer software from the Phantom websites: hips: Ed son Using software such as Win Zip for comparable software) decompress the downloaded zip file and then open the software. 2 Once software is open, plug LIS adapter into computer. Within the software Information window you should see the programmer as “Connected If not, remove the USE programmer from the USE port and re-insert Into the USB port. 2 Conservation to programmer.
USER MANUAL FOR $P V1.1 SERVO PROGRAMMER RATE Programmer Driver Update Instructions 1 FUSE Programmer Driver Update is available, download from the Phantom website. Once downloaded, connect servo to USB programmer. Next, plug programmer Into the LIB port of your computer. Please wait for the USB programmer to automatically update it's driver, This should take approx. 5-10 seconds.
USER MANUAL FOR $P V1.1 SERVO PROGRAMMER RATE 2 During upgrading, the information window will shew the upgrade process, Once complete, will display "Successfully Updated” {see image). w Once the servo firmware is updated, the servo parameters wil be read automatically on the software Interface.
