Instructions / Assembly

1. Installation Preparation

What to Expect with Your Installation

Tools You Need

Must be able to

secure the fan

to building

structure or fan-

rated outlet box

30 inches

from blade

tip to nearest wall or

obstruction

You may need a

friend to help you.

Assess location

Angled Ceilings are

not supported.

If mounting to a support structure, you will also need the optional tools.

Ladder Pliers Screwdrivers

Wire

Strippers

Power Drill

(optional)

Drill Bit

(optional)

7 feet from bottom

edge of blade to the

floor

Check box to see

fan weight

Angled ceiling

not supported.

PAGE 1
. Installation Preparation Tools You Need Ladder Pliers Wire Strippers Screwdrivers Power Drill (optional) Drill Bit (optional) If mounting to a support structure, you will also need the optional tools. What to Expect with Your Installation You may need a friend to help you. 30 inches from blade tip to nearest wall or obstruction Angled Ceilings are not supported.
PAGE 2
. Installing the Fan NOTE: THIS FAN ONLY NEEDS ONE SET OF INPUT WIRES (black, white and ground wire). Both of the fan and lights will be controlled by the remote controller. The wall switch is not able to control the fixture full functionally. THIS FAN CAN ONLY BE CONNECTED ONTO ON/OFF SWITCH IF YOU HAVE ONE, NOT SUITABLE FOR DIMMAER SWITCH. Step 1. Install the bracket Secure the mounting bracket to the ceiling outlet box with the screws and washers provided with your outlet box (Fig. 1). Fig. 1 Step 2.