Installation & Assembly

Copyright 2018 Fanimation
2018/12 V.01
10983 Bennett Parkway
Zionsville, IN 46077
[phone] • FAX [phone]
Outside U.S. call [phone]
WWW.FANIMATION.COM
How to Wire and Operate Your Wall Control
Figure 2
Figure 3
Figure 1
WC2WH Wall Control
DESCRIPTION: Single 3-speed ceiling fan control with light dimmer switch
ELECTRICAL SPECS: 120V, 60Hz Ceiling Fan
FAN MODELS USED: most Fanimation fans - see catalog or visit our website, fanimation.com
for more information
SPECIFICATION and INSTRUCTION SHEET
NOTE: Supply wires and fan wires
omitted for clarity.
1. Connect wires using connectors as shown in Figure 1.
3. Operating Wall Control: (Figure 3)
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan unless blades are in place. Noise and fan damage
could result.
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the wall plate and the wall.
WARNING
Face Plate
Screw
Outlet Box
NOTE: If fan or supply wires are different colors than indicated, have this unit installed by a qualified electrician.
Make wire connections and secure with wire nuts
supplied.
Attach wall control unit to outlet box using the two
screws provided. Then, attach face plate to the wall
control. (Figure 2)
2.
• Restore electrical power.
- Fan off
- Turns light ON/OFF.
- Fan speed control: Turns on fan and turns speed
up or down.
- Light Dimmer: Up or down to brighten or dim
light.
- Indicator LED light
- Pull out to turn all power off.
YELLOW & GREEN
BLUE
BLACK
GROUND
TO MOTOR L
FOR LIGHT
YELLOW & GREEN
BLUE
BLACK
AC IN N
BLACK
AC IN L
• Connect the Black wire from the wall-mounted
control with the wire from the wire of A. C. power
supply.
• Connect the Black wire from the wall-mounted
control with the Black wire from the ceiling fan.
• Connect the Blue wire from the wall-mounted
control with the Blue wire from the ceiling fan.
• Connect the green/yellow wire from the ceiling fan
with the ground wire.