User's Manual

ManualsBrandsFALTEC ManualsElectronicsRemote Controller



- 1 -

Remote Control Engine Starter System

Owner’s Manual

Congratulations on your purchase of the MITSUBISHI MOTORS Remote Control Engine

Starter System. This system will provide you with convenience and assistance, making

each drive a delightful experience.

To take full advantage of your MITSUBISHI MOTORS Remote Control Engine Starter

System please read this manual thoroughly.

Keep this manual handy for easy reference.

Please leave this manual in the car equipped with this remote control engine starter system

at the time of resale.

Mitsubishi Motors Remote Control Engine Starter System is only for vehicles equipped with an

automatic transmission or continuously variable transmission (CVT). Do NOT install Mitsubishi

Motors Remote Control Engine Starter System on vehicles with a manual transmission. Ask an

authorized Mitsubishi Motors dealer for detail.

10, 6

Introduction

1. Introduction ・・・・・・・・・・・・・・・・・・・・・・ 2

2. Features of the System ・・・・・・・・・・・・・・・・・・・・・・ 3

3. Safety Precaution ・・・・・・・・・・・・・・・・・・・・・・ 4

4. Name of each part ・・・・・・・・・・・・・・・・・・・・・・ 6

5. Display ・・・・・・・・・・・・・・・・・・・・・・ 7

6. Operating the Transmitter ・・・・・・・・・・・・・・・・・・・・・・ 8

7. Before Leaving Your Car ・・・・・・・・・・・・・・・・・・・・・・ 12

8. Care and handling ・・・・・・・・・・・・・・・・・・・・・・ 13

9. Replacement of the transmitter batteries ・・・・・・・・ 14

10. Troubleshooting ・・・・・・・・・・・・・・・・・・・・・・ 16

11. Specifications ・・・・・・・・・・・・・・・・・・・・・・ 18

Summary of content (18 pages)

PAGE 1
Remote Control Engine Starter System Owner’s Manual Introduction 1. Introduction ・・・・・・・・・・・・・・・・・・・・・・ 2. Features of the System ・・・・・・・・・・・・・・・・・・・・・・ 3. Safety Precaution ・・・・・・・・・・・・・・・・・・・・・・ 4. Name of each part ・・・・・・・・・・・・・・・・・・・・・・ 5. Display ・・・・・・・・・・・・・・・・・・・・・・ 6. Operating the Transmitter ・・・・・・・・・・・・・・・・・・・・・・ 7. Before Leaving Your Car ・・・・・・・・・・・・・・・・・・・・・・ 8.
PAGE 2
１．Introduction Safety message Throughout this manual the words WARNING and CAUTION appear. These are reminders to be especially careful. Failure to follow the instructions could result in personal injury or damage to your vehicle. Indicates a strong possibility of severe personal injury or death if instructions are not followed. Points out hazards or unsafe practices that could cause minor personal injury or damage to your vehicle. You will see another important symbol; NOTE Gives helpful information.
PAGE 3
２．Features of the System (1) Starting/Stopping the engine - The remote control engine starter system allows you to start or stop the engine by operating the transmitter from outside of the vehicle without using the vehicle key. - However, the transmitter will not start the engine unless all of the following conditions are satisfied; ① The selector lever is in the “P” (Parking) position. ② All doors (including the rear gate and spare tire carrier, depending on model) are securely closed.
PAGE 4
３．Safety Precaution - Never start the engine by using the remote control engine starter system in a closed or poorly ventilated area. Carbon monoxide gas, which is odorless and extremely poisonous, could build up and cause serious injury or death. - Do not operate the transmitter for the remote control engine starter system unless you can see your vehicle. - To prevent accidental engine start, do not touch the transmitter unnecessarily.
PAGE 5
- Do not start the engine without removing the body cover from the car. It can cause fire. - Store the transmitter in a safe place out of reach of children. There is danger of batteries being swallowed. - When parking the vehicle, make sure that the wiper switch and all exterior light switches are turned off and all doors are locked. - Do not disassemble or modify the transmitter. - Do not wet the Transmitter with water. It can cause the transmitter to malfunction.
PAGE 6
４．Name of each part [SIDE] [FRONT] Function SW Switch Lock SW Start SW Switch Unlock SW Stop SW Key ring [REAR] Main body that removed Battery Cover FCC Label Label Battery Cover < Confirm method of FCC Label > Please remove the Battery Cover. The FCC Label appears when the Battery Cover is removed.
PAGE 7
5．Display DISPLAY MEANING NAME Transmission Mark Lighting when signal transmitted. Start Mark Lighting when the engine start operated. Stop Mark Lighting when the engine stop operated. 10 minutes Mark Lighting when idling time setting 10 minutes. 30 minutes Mark Lighting when idling time setting 30 minutes. Battery Mark Lighting when battery discharged. Switch Lock Mark Lighting when Switch lock is set. ※ Refer to each item about details of each operation.
PAGE 8
6．Operating the Transmitter Before operating the transmitter Make sure that all conditions listed on page 12 are satisfied. Starting Engine 1 Push Function SW short once. Start Mark will blink for about 3 seconds as shown in a right figure. Function SW 2 Push Start SW until buzzer sounds, while Start Mark is blinking. Either 10minutes Mark or 30minutes Mark, Start Mark and Transmission Mark will stay on as shown in a right figure.
PAGE 9
Stopping the Engine 1 Push Stop SW until buzzer sounds. Transmission Mark and Stop Mark will stay on as shown in a right figure. ● Other engine stop conditions The engine also stops by any of below conditions. ①The engine hood is opened. ②The selector lever is not in the “P” position. ③Any door is opened. ④ The key is inserted into the ignition switch or Stop SW the ignition knob is pushed. ⑤The setting idling time has passed.
PAGE 10
Setting the idling time 1 Function SW Push Function SW and Start SW at the same time until buzzer sounds. 10 minutes Mark or 30 minutes Mark will blink according to the present setting . In case the present setting is Start SW “10 minutes” 2 Push Start SW short, and decide the idling time. Selected idling time’s Mark blinks. Start SW 3 Push Function SW until buzzer sounds. The idling time’s Mark decided stays on for about 2 seconds.
PAGE 11
Switch Lock setting and release This function effects for the prevention of unexpected transmission in trouser pocket, handbag, and so on. The switches of the transmitter are locked and released if the below operation is done. 1 Push Function SW and Switch Lock SW at the same time until buzzer sounds. Switch Lock SW Function SW Switch Lock Mark stays on for about 2 seconds, and Switch Lock is set. 2 Push Function SW and Switch Unlock SW at the same time until buzzer sounds.
PAGE 12
7．Before Leaving Your Car When leaving your vehicle, make sure the following conditions are satisfied. (1) The selector lever is in the “P” (Parking) position. (2) All doors (including the rear gate and spare tire carrier, depending on a model) are securely closed. (3) The engine hood is securely closed. (4) The vehicle key is removed from the ignition switch. For vehicle equipped with the Free-hand Advanced Security transmitter (F. A. S. T. –key), the ignition switch is on the Lock position.
PAGE 13
8．Care and handling Obey the following notes to prevent a breakdown and an unexpected accident of this system. - Store the transmitter in a safe place out of reach of children. Moreover, please contact the shop that purchases it at once when it loses and abnormality is found. - Do not pass the transmitter for an emergency prevention of accidents when the car is lent to others or the key is entrusted. Transmitter - Do not leave it in the hot place (60℃ or more) such as on the dashboard.
PAGE 14
9．Replacement of the transmitter batteries The Battery Mark on the display stays on when any switch is operated, while the battery is discharged. In this case, exchange it for 2 pieces new battery at the same time. Especially, the battery performance decreases at the low temperature. Battery Replacement 1 Slide the Battery Cover grip, and gently detach the Battery Cover from the transmitter.
PAGE 15
NOTE Wipe the new batteries with a dry and clean cloth. - Store the batteries out of reach of children especially. If a child accidentally swallows it, give him/her medical treatment immediately. - Do not hold batteries with metallic tools, such as tweezers. It can short-circuit the batteries and may generate heat. - Do not disassemble, heat or throw the removed batteries in fire. This may cause explosion, etc.
PAGE 16
10．Troubleshooting When the transmitter does not start/stop the engine, check the following before consulting your dealer. Engine does not start by operating the transmitter. 【Switch Lock Mark stays on.】 Check Remedy When the switch of the transmitter is pushed, does the Switch Lock Mark stay on? Release Switch Lock. Refer to page 11, “Switch Lock setting and release”. 【Battery Mark stays on.
PAGE 17
The engine does not stop by the Transmitter. Check Remedy Is the vehicle too away to receive the transmitter signal? Approach to the vehicle, and then use the transmitter. Has the engine started by the ignition switch? Stop the engine by ignition switch. The transmitter can stop engine, only when the engine has been started by operating the transmitter. The distance that can be operated is short. Check Are the transmitter batteries discharged? Remedy Replace them to new batteries.
PAGE 18
１1．Specifications Main Unit(Receiver) Transmitter Communication Communication 426.0500MHz frequency Communication uni-directional method frequency Communication (transmission.) method Application standard FCC conforming Receiving antenna Transmission time approximately 3 seconds Operation Transmission rest time power-supply Two seconds or more Built-in antenna antenna uni-directional (receiving) Coaxial cable whip antenna DC10V〜16V voltage Current Transmission 426.