Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
1 2 3 4 5 6 7 8 9 13 Tremblr-usermanualOUTLINES.
1 14 Tremblr-usermanualOUTLINES.
Inches mm 5 127 5.5 140 6 152 6.5 165 7 178 7.5 191 8 203 8.5 216 9 229 2 3 15 Tremblr-usermanualOUTLINES.
WARNING! Never attempt to adjust anything on the F-Machine whilst it is operating/moving. Always disconnect from the mains power socket before making any adjustments or carrying out any maintenance. Set the switch to the OFF position before connecting the power supply. Note: The guard window is not shown in the illustration for clarity – never operate the machine without the window installed. 16 Tremblr-usermanualOUTLINES.
4 WARNING! Always ensure that the F-Machine is connected to an electrical outlet that has an earth connection and is protected by a miniature circuit breaker (MCB), and a residual current device (RCD) circuit which reduces the risk of electric shock. 5 17 Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Note: All Tremblr machines come with a remote control handset to control the machine. Depending on the product type that you purchased, you may also have Bluetooth capability to control the Tremblr – refer to Section 6 about using the Bluetooth App. 19 Tremblr-usermanualOUTLINES.
Note: The F-Machine Tremblr electronics have been designed to cut out if the motor is stalled for any reason. This is most likely to happen if the pipe between the pump unit interface panel and the receiver becomes kinked over and blocks the air flow. You will get an indication of this because the pump will stop turning and the red stall indicator LED on the chassis will light up (visible through the window – see fig. 2.2). 20 Tremblr-usermanualOUTLINES.
6 21 Tremblr-usermanualOUTLINES.
7 8 22 Tremblr-usermanualOUTLINES.
9 23 Tremblr-usermanualOUTLINES.
Note: It is very important that there are no cuts or nicks in the end of the sleeve before it is fitted, as this can lead to a tear in the sleeve. Always ensure you have a clean cut all the way around. 24 Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Sequential checklist carry out in following order What to expect under normal conditions Check 1. Is the power supply working correctly? • The blue LED on power supply should light up when switched on • No signs of visible damage to cables or connectors • Mains cable should be fully pushed into power supply • Output voltage should be ~24Vdc (use voltmeter) • Chec • Chec if nee • Chec • Chec for da 2.
chine ed rol under leaks Checks to perform (if not working) Possible causes/resolutions • Check wall socket working (with another appliance) • Check plug, fuse (if applicable), swap mains power cable if needed • Check/swap travel adapter (if using one) • Check wires between power supply and the interface panel for damage and replace if needed • If still not working, replace the power supply with a genuine part • Contact F-Machine • Check the 90 degree power connector is fully inserted into
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
Tremblr-usermanualOUTLINES.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.