Instructions / Assembly

ManualsBrandsEZ-ACCESS ManualsAccessibility RampsFORTRESS 23 in. to 34 in. H OSHA Compliant Aluminum 3-Riser Stair System with Platform and Canopy

Manufactured in the USA

All text and images contained in this document are proprietary and may not be shared, modified,

distributed, reproduced, or reused without the express written permission of EZ-ACCESS.

12963 REV 02-13-2020

FORTRESS® OSHA Stair System

Adjustable Temporary Stair

Installation Manual

3-TREAD at 25.5”

3-TREAD at 34”

4-TREAD at 34”

4-TREAD at 42.5”

Summary of content (6 pages)

PAGE 1
FORTRESS® OSHA Stair System Adjustable Temporary Stair Installation Manual 3-TREAD at 25.5” 3-TREAD at 34” 4-TREAD at 34” 4-TREAD at 42.5” Manufactured in the USA © EZ-ACCESS®, a division of Homecare Products, Inc. All rights reserved. All text and images contained in this document are proprietary and may not be shared, modified, distributed, reproduced, or reused without the express written permission of EZ-ACCESS.
PAGE 2
INTRODUCTION This manual covers installation for the FORTRESS® OSHA Stair System and its components and hardware. Throughout this document, the FORTRESS® OSHA Stair System may also be referred to as “system”. IMPORTANT SHIPPING INFORMATION • Refer to the packing list and confirm all items are present before starting installation. Open shipping boxes and inspect for damage or missing parts. If damaged or missing parts are noted, do not install or use.
PAGE 3
FIG.
PAGE 4
1. INSTALLATION 1.1. 1.2. 1.3. 1.4. 1.5. 1.6. 1.7. 1.8. 1.9. 1.10. 1.11. 1.12. 1.13. Set platform on its side. Loosen platform leg adjustment bolts in each platform corner pocket, but do not remove. Adjust legs to desired height and securely retighten platform leg adjustment bolts and washers (FIG. 2). If using oversized feet, see ‘OVERSIZED FEET INSTALLATION (OPTIONAL EQUIPMENT)’ section. Set platform in upright position. Readjust the height of each platform leg as necessary to level the platform.
PAGE 5
2. OVERSIZED FEET INSTALLATION (OPTIONAL EQUIPMENT) 2.1 2.2 2.3 2.4 Loosen the leg adjustment bolts in each platform and riser corner pocket, but do not remove; then remove the existing legs (FIG. 2). Insert the legs included with the oversized feet into the corner pockets with the open side of the channel oriented toward the leg adjustment bolt & washer and the square nut inside the leg (FIG. 4). The two short legs install in the bottom of the riser and the four long legs install in the platform.
PAGE 6
3. PLATFORM CANOPY INSTALLATION (OPTIONAL EQUIPMENT) 3.1 3.2 3.3 3.4 3.5 3.6 Remove handrails from system (if installed) and set aside. Use extreme caution on platform when no handrails are present. Insert 1-1/2” square canopy posts into platform corner pockets (FIG. 5). Set canopy roof on canopy posts. Insert top of canopy posts into canopy roof corner pockets and tighten corner pocket set screws (FIG. 5).