User’s Guide V-Lock™ Wall Mount Assembly Kit ® Replacement accessory for Extron System INTEGRATOR SI 3 Surface Mount Speakers 68-1490-01 Rev.
Introduction Packaging Information The V-Lock™ Assembly Kit contains two individually packed wall mount assemblies (one for each speaker) and an Allen hex tool. Allen Hex Tool Wall Mount Assemblies Outer Packaging Figure 1 — V-Lock Assembly packaging details About the V-Lock Assembly Kit The V-Lock Wall Mount Assembly Kit is a pair of replacement wall mount assemblies (wall plate and V-lock groove only) for the Extron System INTEGRATOR® SI 3 surface mount speakers.
Installation Installing the V-Lock™ Assembly Kit If your speakers are not already installed, follow the instructions outlined in the SI 3 User's Guide supplied with the speakers (or online at www.extron.com). If your speakers are already installed, replace the V-Lock assembly by following the instructions, below. N Referring to packaging information for location, carefully remove and check contents before installation.
Installation, cont'd 4. Rotate the stage (V-lock groove) 90 degrees to the wall plate (see figure 4), to access the screws in the wall plate. Rotate this section 90°... ...and remove screws. Figure 4 — Remove the old V-Lock Assembly 5. Carefully remove and retain the mounting screws, taking care not to damage the mounting holes in the wall. Remove the mount from the wall. 6.
Mounting the speakers Carefully lift the speaker above the wall mount assembly and gently slide the speaker box bracket down into the V-lock groove (see figure 6) until it locks into place. 1. ...and slide it down into the V-lock groove. Lift the speaker up to the wall mount assembly.... Box Bracket Box Bracket V-Lock Groove V-Lock Groove Figure 6 — Slide the speaker down onto the wall mount assembly 2.
Installation, cont’d Final adjustments 1. Turn on the audio source and any associated devices. Adjust the source and device settings as desired to get the optimum audio output for your speaker application. 2. To adjust the speaker angle insert the allen hex tool into the locking access, loosen the hex cap screw, and adjust to the desired angle (see figure 7). Tighten the hex cap screw down about 6 to 8 turns clockwise, until snug, for the speaker to sit securely in the desired position.
Extron’s Warranty Extron Electronics warrants this product against defects in materials and workmanship for a period of five years from the date of purchase.
www.extron.com Extron Electronics, USA 1230 South Lewis Street Anaheim, CA 92805 800.633.9876 714.491.1500 FAX 714.491.1517 Extron Electronics, Europe Beeldschermweg 6C 3821 AH Amersfoort, The Netherlands +800.3987.6673 +31.33.453.4040 FAX +31.33.453.4050 Extron Electronics, Asia 135 Joo Seng Rd. #04-01 PM Industrial Bldg., Singapore 368363 +800.7339.8766 +65.6383.4400 FAX +65.6383.4664 © 2008 Extron Electronics. All rights reserved.