Installation Guide CVC 300 Component Video and HDTV to RGB Converter 68-1541-01 Rev.
Introduction The Extron CVC 300 Component Video Converter converts all standard component video formats: NTSC/PAL, DVD, and Betacam®, to RGBHV or RGBS; and converts SMPTE HDTV component video to RGBHV. The CVC 300 can also strip sync-on-green (SOG) from RGsB video. The converter outputs RGBHV or RGBS video on BNC connectors. The figure below shows a typical CVC 300 application.
Mounting 2. Reduced air flow — Install the equipment in a rack so that the amount of air flow required for safe operation of the equipment is not compromised. 3. Mechanical loading — Mount the equipment in the rack so that a hazardous condition is not achieved due to uneven mechanical loading. 4. Circuit overloading — Connect the equipment to the supply circuit and consider the effect that circuit overloading might have on overcurrent protection and supply wiring.
Cable Connection and Rate Selection Cable Connection and Rate Selection See the illustrations below to identify the panel connections. b PR/R POWER R 12V 1.0 A MAX INPUT d Y/G PB/B G B CVC 300 FORMAT V H/HV CVC 300 OUTPUT a e c a b Y, PR, PB Video RGsB (SOG) Video c Power connector — Plug the external 12 VDC power supply here using the included 2-pole captive screw connector (See "Power supply wiring").
Cable Connection and Rate Selection (Cont’d) e Input Format rotary switch — Use an Extron Tweeker or other small screwdriver to set the Format rotary switch to match the video input format. The following table shows switch settings and their assigned input video formats.
Power Supply Wiring Power supply wiring N This product is intended to be powered by a UL Listed power supply with an output rated at 12 VDC, 2 A. Wire the supplied male power connector (plug) as shown below. Smooth Ridges A A + _ SECTION A–A Power Supply Output Cord Tie Wrap 3 5 Captive Screw Connector C Power supply voltage polarity is critical. Incorrect polarity can damage the power supply and the product. Identify the power cord negative lead by the ridges on the side of the cord.
Specifications Video input Number/signal type ��������������������� 1 component video [HDTV (Y, PR, PB), SMPTE (Y, R-Y, B-Y), or Betacam® (Y, R-Y, B-Y)] or RGsB Connectors ������������������������������������� 3 BNC female Nominal level �������������������������������� 1 Vp-p for Y of component video and for G of RGsB 0.7 Vp-p for PB, PR, R-Y and B-Y of component video, and for R and B of RGsB Minimum/maximum levels �������� 0 V to 1.
Specifications (Cont’d) General External power supply ����������������� 100 VAC to 240 VAC, 50-60 Hz, external; to 12 VDC, 2 A, regulated Power input requirements ����������� 12 VDC, 1.0 A Temperature/humidity ���������������� Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +104 °F (0 to +40 °C) / 10% to 90%, noncondensing Cooling ������������������������������������������� Convection, no vents Mounting Rack mount ������������������������ Yes, with optional 1U, 9.
