Installation Guide
Table Of Contents
- Table of Contents
- Preface
- Product Overview
- Install the Access Point
- AP310i/e Box Contents
- Access Point Installation Options and Accessory Information
- Install the Access Point on Drywall or Wood Wall, or to a Solid Flat Ceiling
- Install the Access Point on a Suspended Ceiling or a Drop Ceiling with a Flat T-bar
- Install the Access Point on a Junction Box or Gang Box
- Install the Access Point on a Beam
- Antenna Configuration for External Antenna Model Access Point
- Access Points Specifications
- Regulatory Information
- Safety Guidelines
- MPE Statement for Mobile Devices
- Federal Communications Commission (FCC) Notice
- Industry Canada Notice
- Detachable Antenna Usage
- Australia Notice
- Brazil Anatel Statement
- Hazardous Substances
- Supplement to Product Instructions
- NCC Statement
- CE Information
- European Waste Electrical and Electronic Equipment (WEEE) Notice
- Declaration of Conformity in Languages of the European Community
- Index
Install the Access Point on a Flat T-bar Using Main Mounting Bracket
Before You Begin
Ensure that the T-bar meets the following conditions before installing the main mounting bracket on a
flat T-bar:
• T-bar width must be 15/16 in. (24 mm).
• T-bar bottom must be flat, all the way across the ceiling.
• T-bar must be structurally sound.
• T-bar maximum base thickness must not exceed 0.055 in. (1.4 mm).
• Ceiling tile over the T-bar must be flat, all the way across.
About This Task
The main mounting bracket is used on a T-bar when the ceiling model is a suspended or drop ceiling
and when there is a T-bar on the ceiling.
Procedure
1. Remove the ceiling tiles.
Install the Access Point on a Flat T-bar Using Main
Mounting Bracket Install the Access Point
22 ExtremeWireless™ AP310i/e Access Points
DRAFT