Installation Guide
Table Of Contents
- Table of Contents
- Preface
- Product Overview
- Install the Access Point
- AP310i/e Box Contents
- Access Point Installation Options and Accessory Information
- Install the Access Point on Drywall or Wood Wall, or to a Solid Flat Ceiling
- Install the Access Point on a Suspended Ceiling or a Drop Ceiling with a Flat T-bar
- Install the Access Point on a Junction Box or Gang Box
- Install the Access Point on a Beam
- Antenna Configuration for External Antenna Model Access Point
- Access Points Specifications
- Regulatory Information
- Safety Guidelines
- MPE Statement for Mobile Devices
- Federal Communications Commission (FCC) Notice
- Industry Canada Notice
- Detachable Antenna Usage
- Australia Notice
- Brazil Anatel Statement
- Hazardous Substances
- Supplement to Product Instructions
- NCC Statement
- CE Information
- European Waste Electrical and Electronic Equipment (WEEE) Notice
- Declaration of Conformity in Languages of the European Community
- Index
Figure 1: Main mounting bracket
Callout Description
1 Main mounting bracket mounting holes
2 Main mounting bracket feet
2. Insert the Phillips pan head screws into the main mounting bracket holes and attach the bracket to
the w
all.
Use screw-in anchors, if needed.
3. Connect the Ethernet cable RJ45 connector into the GE1 port.
4. Place the access point onto the bracket feet and slide it down to lock it in place.
Install a Security Torx Locking Screw
About This Task
The security torx locking screw is used to prevent the access point from being removed from the main
mounting bracket (#37201). There are two security lock screw holes on the rear of the access point.
Install the Access Point
Install the Access Point Using the Main Mounting
Br
acket
ExtremeWireless™ AP310i/e Access Points 17
DRAFT