Extreme Networks, Inc. Product Specification PCE3200AH V. 0.3 Revision History Version Date Revision Description 0.1 2012/2/4 Preliminary 0.2 2012/6/27 1. connector change to MMCX 2. Revised the operating temperature support range 3. Revised on the radio transmit power and sensitivity specification 0.3 PCE3200AH 2012/10/09 1. Improved TX power.
Extreme Networks, Inc. PRODUCT DESCRIPTION The PCE3200AH is a adapting up-to-date Qualcom chip, AR9590B (i-temp support), and targeting for enterprise-class platform. It is acting at 2.4GHz frequency band. PRODUCT SPECIFICATION General information Chipset Atheros AR9590B PA SE2576L Interface PCIe Need both 3.3V and 5V voltage input Operating voltage PCIe Slot : DC 3.
Extreme Networks, Inc. Regulation Certifications FCC Part 15 Preliminary Radio Specification Typical AVG. Power Channel Data rate Typical RX Sensitivity Tolerance @combined(dBm) @ combined(dBm) 1 Mbps(no compliance with 802.11b (2.412~2.472GHz) ≦-95 dBm 29 +1/-2 dB 1 ~ 2 Mbps 29 +1/-2 dB 5.
Extreme Networks, Inc. Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Extreme Networks, Inc. This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 30 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
Extreme Networks, Inc. Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 30cm between the radiator & your body. Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non contrôlé.
Extreme Networks, Inc. l'intégrateur OEM sera chargé de réévaluer le produit final (y compris l'émetteur) et l'obtention d'une autorisation distincte au Canada. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 30 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains IC: 4141B-24G32”.
Extreme Networks, Inc. Use only the antennas which have been approved by the applicant. The non-approved antenna(s) may produce unwanted spurious or excessive RF transmitting power which may lead to the violation of FCC/IC limit and is prohibited. 4. Installation procedure Please refer to user’s manual for the detail. 5. Warning Please carefully select the installation position and make sure that the final output power does not exceed the limit set force in relevant rules.