Getting Started Guide

4
WIRELESS SENSOR ( )
1
2
3
4
1. Battery compartment
2. TX: Searches for weather station
3. Channel switch
4. Open the battery compartment.
GETTING STARTED
INSTALL BATTERIES IN MAIN UNIT
1. Remove the battery compartment cover.
2. Insert the 2x AA batteries, matching the polarities.
WIRELESS SENSOR
The main unit can collect data from up to 3 sensors.
To set up the sensor:
1. Open the battery compartment.
2. Slide the channel switch to select a channel.
3. Press TX after each battery change.
3. Close the battery door.
4. Place the sensor with in 30 m (98 ft) of the main unit.
TIP
Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 1.5 m (5 ft) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
150cm(5ft)
NOTE
• Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures
below freezing.
• Replace the batteries when
displays, or when
the display backlight is dim.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS
outdoor sensor