User's Manual

User Instruction Manual

Gateway Installation:

1. Connect the Gateway to the internet via the supplied Ethernet cable. Use a port on the

internet modem or router labeled with “LAN” or “Ethernet”. Power the Gateway.

2. Connect the supplied USB cable to the power adaptor (5V), plug the smallest connector

of the USB cable in the gateway.

3. Insert the power adaptor in a power outlet. The device will turn on and several lights start

to blink. When the power light stays continuously on, the device is ready

Gateway LED direction：

1. Green LED - Power light, and show the Ethernet connect is normal or not;

2. Orange LED - Pairing & Zigbee

3. Red LED - Error

PAGE 1
User Instruction Manual Gateway Installation: 1. Connect the Gateway to the internet via the supplied Ethernet cable. Use a port on the internet modem or router labeled with “LAN” or “Ethernet”. Power the Gateway. 2. Connect the supplied USB cable to the power adaptor (5V), plug the smallest connector of the USB cable in the gateway. 3. Insert the power adaptor in a power outlet. The device will turn on and several lights start to blink.
PAGE 2
PIR Sensor Installation: 1. Open the casing by detaching the back plate from the device. Place the AA batteries inside the sensor; Close the casing, you will hear a “click” when done properly. 2. Drill a hole in the hole at about 1.4 meters high. Use the provided wall plug to turn the screw in the wall. 3. Mount the sensor by sliding the hole in the top of the back plate over the screw in the wall. Make sure the lens is pointing upwards.
PAGE 3
Door/window Sensor Installation: 1. Place the sensor body and magnet on door or window by double-sided tape on the back. Make sure the dots on both devices are close to each other. 2. The gap of door or window must less than 10mm FCC Statement: This device complies with part 15 of the FCC Rules.