User's Manual

- 1 -
HSC04-0 U-Net Gateway
User Manual
1. Introduction
The HSC04 Gateway is a member of the U-Net series and is fully compatible
with any U-Net enabled devices. It can remotely control and monitor your
U-Net enabled devices. Whether onsite or logged in through the internet, you
will always have access to control and monitor your control system. With this
system you can achieve a better control of your home security to make your
life safer and easier than ever.
2. Appearance
Figure 1 HSC04 Appearance
2.1 Sockets
DC Jack: DC power voltage
9V, current 2A.
RJ-45 socket: HSC04 has
an Ethernet hub function
and is equipped with two
linked RJ-45 sockets.
2.2 Buttons
HSC04 has two buttons:
One reset button and a
connection button (next to
the RJ-45 socket).
■ Reset Button:
This button will reboot the system. The user can press this button when the
system is halting.
Note: HSC04 is equipped with internal battery power, which will be
automatically switched to when DC power is cut off. The device will still
be halting.
■ Connection Button:
‧ Manually enable the bind function:
Press the connection button once after the system is powered on.
 ‧ Manually cancel the bind function:
Press the connection button once when the system is in bind mode.
2.3. LED
Figure 2 HSC04Front View
LED1 LED2 LED3 LED4