User's Manual

Instruction Manual for
RF Remote Socket and Transmitter
Ref: EMW200R-UL + EMW203T1
Function
1. The remote control socket turns on and off the appliance by a wireless transmitter using radio
frequency up to 25 meters away.
2. It is ideal for controlling appliance for the purposes of home automation and energy saving.
3. Each transmitter controls up to 3 channels. Each channel can command up to 3 receivers.
Operation
1. Check the group setting at the back of the transmitter, A, B, C or D. If the transmitter is in group
A, then, the commanded receiver has to be in the same group setting.
2. Check the group setting at the back of the receiver is same as transmitter and the channel no,
eg. A1, A2 or A3
3. Connect the remote control socket to the mains power supply.
4. Press the corresponding “ON”, “OFF” buttons on the transmitter to switch on and off the
connected appliance by remote control. (eg. on/off buttons 1 controls receiver A1, 2 controls
receiver A2, 3 controls A3)
5. The indicator on the receiver blink once for every reception of power on/off
Caution
1. For safety reason, always switch off your appliance before connection and avoid setting up on
rainy days.
2. Appliances to be connected to the remote control socket MUST NOT exceed the voltage and
frequency ratings as in “Specifications”.
3. To adjust the channel or the groups, always use a big screw driver with the same diameter as
the adjustment arrow at the back of the socket and receiver. A small screw driver will deform the
plastic housing during adjustment.
Specifications
EMW200R-UL,
1. Power Rating : 125V~, 60Hz, 1000W
2. Frequency: : 433.92 MHz
3. Distance: : 25 meters
EMW203T1
Battery : CR2032
Frequency : 433.92 MHz
1. Distance : 25 meters max.
Holder:
Everflourish Electrical Co., Ltd.
Renjiu Village, Wuxiang Town, Yinzhou, Ningbo, 315111 P.R. China
Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Prudence
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for