Installation Guide

Installation Guide

Fixed Mount System Tips

HOMEDEPOT.com

Please contact 1-800-305-1726 for further assistance.

Install Shelf and Support Brackets

Install Wall Clips

Prepare Shelves

Fixed Mount Components

E. Closet Rod

F. Shelf Endcap

G. Closet Rod Endcap

A. Wall Clip

B. Regular Duty Shelving

C. Support Bracket

D. Closet Rod Support Bracket

a. Push shelf into wall clips rmly, allowing shelf to hang down from

installed clips.

b. Position support brackets on top front lip of shelf as shown, no more

than 36 in. apart and 6 inches in from ends of shelf as shown.

c. Level the shelf and drill a 1/4 in. hole through the hole in the wall

bracket where it meets the wall as shown.

d. Line up bracket hole with drilled hole and push the anchor into the

hole, then push the pin into the anchor using the handle of a

hammer or similar tool. If removal is needed, you may pry the pin

out with a at screwdriver.

□ Cut shelf to desired length using a hacksaw or bolt cutters, if necessary. Place

provided end caps over cut ends. Caution - cut ends of shelf are sharp, immediately

use end caps to cover.

a. Draw a level line lightly on the wall the entire length of the shelf. Make a mark 2

inches in from each end of shelf to install wall clips. Measure total distance

between end clips and divide evenly, making marks for remaining clips. Clips

should be spaced no more than 12 in. apart.

b. Drill 1/4 in. holes at each marked location for wall clips (Do NOT punch holes).

c. With a hard at object such as a hammer handle, push wall clip into pre-drilled hole

then insert pin into wall clip. If removal is needed, you may pry the pin out with a

at screwdriver.

Example of 6ft Shelf Installation

2 in. (5.1 cm) 2 in. (5.1 cm)

11 in. (27.9 cm)

11 in. (27.9 cm) 11 in. (27.9 cm)

11 in. (27.9 cm) 12 in. (30.5 cm)

12 in. (30.5 cm)

1/4 in.

6 ft.

183 cm

PAGE 1
Installation Guide Fixed Mount System Tips F A B G C E D Fixed Mount Components A. Wall Clip E. Closet Rod B. Regular Duty Shelving F. Shelf Endcap C. Support Bracket G. Closet Rod Endcap D. Closet Rod Support Bracket 1 Prepare Shelves □ Cut shelf to desired length using a hacksaw or bolt cutters, if necessary. Place provided end caps over cut ends. Caution - cut ends of shelf are sharp, immediately use end caps to cover. 2 Install Wall Clips Example of 6ft Shelf Installation a.
PAGE 2
4 Install Rod Support Brackets and Rods □ Put the closet rod support bracket at an angle as the diagram shows and place the back part onto the horizontal rod. Max spacing between closet rod support brackets is 36 in. for the regular duty system. □ Cut closet rod to desired length, if necessary. Place closet rod end caps onto each end of closet rod and snap the rods into the rod support brackets. Caution - cut ends of closet rod are sharp, immediately use closet rod end caps to cover.