Installation Guide

ManualsBrandsEverbilt ManualsShelving84 in. L White Steel Heavy Duty Vertical Rail

Installation Guide

Heavy Duty System Tips

HOMEDEPOT.com

Please contact 1-800-305-1726 for further assistance.

Install Hang Tracks

Choose Your Hardware

Heavy Duty System Components

A. Heavy Duty Hang Track

B. Heavy Duty Vertical Rail

C. Heavy Duty Shelf Bracket

D. Heavy Duty Closet Rod

E. Heavy Duty Closet Rod Support Bracket

F. Heavy Duty Closet Rod Endcap

G. Heavy Duty Shelving

Secure to the wall with #12x2 in.

panhead screws at stud locations.

Drill 1/4 in. holes, insert 1/4 in. wall

anchors and secure to the wall with

#12x2 in. panhead screws.

STUDS

CONCRETE

DRYWALL

Drill a 1/2 in. hole in the drywall. If

you hit a stud during drilling, use

above stud hardware/instructions

for each stud location.

Insert bolt through hang track (or

vertical rail/vertical rail joiner) then

screw on 3/16 in. toggle.

Install 3/16 in. toggles in each hole of

the component you are attaching

before attaching to the wall.

Compress and pass the 3/16 in.

toggles through the hole you drilled.

Allow the 3/16 in. toggle to spring

apart behind the drywall.

Screw the 3 in. bolt until tight to

secure. Pull back on screw head

for tension if 3/16 in. toggle is

spinning behind wall. Install 3/16

in. toggles in each hole of

components before attaching to

wall.

□ Determine your desired hang track conguration per your planned layout.

□ Measure 84 in. from the oor and level the hang track. Use a pencil to mark each screw hole, marking at least every 16 in.

apart (or closer) along hang track on the wall.

Summary of content (2 pages)

PAGE 1
Installation Guide Heavy Duty System Tips A B G C E F D Heavy Duty System Components A. Heavy Duty Hang Track E. Heavy Duty Closet Rod Support Bracket B. Heavy Duty Vertical Rail F. Heavy Duty Closet Rod Endcap C. Heavy Duty Shelf Bracket G. Heavy Duty Shelving D. Heavy Duty Closet Rod 1 Choose Your Hardware STUDS CONCRETE Secure to the wall with #12x2 in. panhead screws at stud locations. Drill 1/4 in. holes, insert 1/4 in. wall anchors and secure to the wall with #12x2 in. panhead screws.
PAGE 2
3 Install and Secure Vertical Rails □ Attach the vertical rails to the hang track slots as show in the diagram, utilizing a level to keep vertical rails straight/plumb. Ensure the center-to-center space is NO MORE than 16 in. apart and keep minimum space of 2 in. at the ends of the hang track. □ Determine the correct hardware to secure the vertical rail. 4 ATTACH INSERT 1 Install Brackets □ Insert shelf brackets to the vertical rails at your desired positions.