How-To Guide

Ever Sparkle Technologies Limited

Controller Operation Procedure

A. Below is the Control button layout drawing

B. How to operate the buttons

1. [Power/OK] button

i. Press once to power on the controller. The default setting ofturn off time is 15 minutes. The unit will be

turned off as per the Timer setting.

ii. To turn off the controller when timer has not been reached, press and hold the [Power/OK] for 3 seconds.

iii. Use [Up] / [Down] buttons to adjust the power level. There are total 5 levels can be set.

Remark: When reaches to level 5 and press the [Up] button, the level 5 LED will be flashed with 0.5 sec

interval. When reaches to level 1 and press the [Down] button, the level 1 LEDwill be flashed with 0.5 sec

interval.

When the temperature has been raised to a comfortable level, press the [Power/OK] button once to fix the

temperature.

Question: - How to operate on App?

iv. The temperature set by above item ‘iv’ will be released when [Up] or [Down] button is pressed.

v. The temperature setby above step ‘iv’ will be stored in the memory. When the unit has been powered on

again without pressing the [Up]/[Down] buttons, the same temperature setting will be applied.

vi. The maximin temperature will be set at 50 degrees C.

vii. To further increase the temperature to above 50 degrees, press and hold the [Up] button for 5 seconds.

viii. The temperature will not be increase when reaches 60 degrees C.

2. Down button

Each press on the button will reduce the power by one step.

3. Level Indicator (LEDs)

To indicate the power level.

4. Up button

Each press on the button will increase the power by one step.

5. Timer button

i. Default is 15 minutes when power on.

ii. Press once to switch to 30 minutes.

PAGE 1
Ever Sparkle Technologies Limited Controller Operation Procedure A. Below is the Control button layout drawing B. How to operate the buttons 1. [Power/OK] button i. Press once to power on the controller. The default setting ofturn off time is 15 minutes. The unit will be turned off as per the Timer setting. ii. To turn off the controller when timer has not been reached, press and hold the [Power/OK] for 3 seconds. iii. Use [Up] / [Down] buttons to adjust the power level.
PAGE 2
iii. Press one more time to switch to 60 minutes. iv. When pressing the Timer button continuously, it will be cycledbetween 15 minutes to 60 minutes. 6. FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.