Installation Guide

©2018. Euri Lighting | A Division of IRTRONIX Inc. All Rights Reserved
PLEASE REVIEW THE INSTRUCTIONS AND WARNINGS LISTED BELOW PRIOR TO PROPER INSTALLATION
WARNINGS CAUTIONS
Risk of fire / electrical shock .
LED Panel installation requires knowledge of luminaire electrical
systems.
Risk of electric shock – disconnect power at source before installation.
Do not make or alter any open holes in an enclosure of wiring or
electrical components during installation.
If lamp or luminaire exhibits abnormal operation (buzzing, flickering,
minimal light, etc.), turn off power, remove luminaire and contact us.
For more information please visit www.eurilighting.com or call our
toll-free number 1-888-743-5766.
• Do not look directly at the operating LED Panel.
Do not touch this product with wet hands.
Do not disassemble, repair or alter lamp.
Designed for indoor applications only.
Suitable for damp locations.
The luminaires should be grounded.
This device is not intended for use with emergency exits or
emergency lights.
Please make sure the driver supply wiring is of adequate length and
rating. Avoid any tension.
Observe proper polarity when connecting power to driver. Unit must be
grounded as per code. L = Input Line or Hot, W = Neutral
All connections should be according to NEC or any applicable local
code.
Wear gloves and safety glasses every time when working with the
luminaire for installing, servicing or performing maintenance.
INSTALLATION INSTRUCTIONS
For customer service please call us at 1-888-743-5766
Questions?
LED Troffer Series | 2x2 Class| 2x4 Class
LED
Troffer
2 ft. x 2 ft.
Ultra Slim
2 ft. x 4 ft.
INSTALLATION GUIDE
MODEL #: ETF22-2040s-2 / ETF24-2040s-2
LED Troffer Mounting
STEP 1:
Install the four(4) supplied T-BAR clips into the
mounting bracket on the outside of the housing.
STEP 2:
Put the troffer into the T-BAR Ceiling Panel and attach the clips on the
housing onto the T-Bar
STEP 3:
Fix the safety cable at the back side of the house to the ceiling in case
the troffer drop down
LED Troffer Wiring
1. Wire input end of the LED driver to supply wires using connector
according to wiring section. Wire connections must be insulated.
2. Connect the BLACK/BROWN lead to LINE (+) supply lead.
3. Connect the WHITE/BLUE lead to NEUTRAL/COMMON(-) supply
lead.
4. Connect the GREEN lead to GROUND supply lead.
5. If any, connect PURPLE/BLUE to 0-10V SIGNAL supply lead and
GREY/WHITE to 0-10V NEUTRAL/REFERENCE supply lead.
Junction Box
Knock Outs
T-Bar Clips

Summary of content (1 pages)